User`s manual

INP-TN5A0202-E 5-23
5.5 Address Map and Data Format
Memory confi guration (Setting area)
Contents Reading out/Writing data setting range Factory-set
value
Register No.
Setting area device type 00A8h: Data register (D)
00B4h: Link register (W)
00AFn: File register (R)
00B0h: File register [for sequence No. access](ZR)
00A8h 40011
Setting area start address (lower) Addressable range: according to PLC setting 1000 40012
Setting area start address (upper) Addressable range: according to PLC setting 0 40013
Setting area device size 0 to 712 0 40014
Setting area entry St. No.
(The 1
st
word)
0 : Not used
1 to 16 : Control/Analog module
17 to 32 : Event module
0 41001
Setting area entry register No.
(The 1
st
word)
0,40000 to 49999 (Note1) 0 41002
Setting area entry St. No.
(The 2
nd
word)
0 : Not used
1 to 16 : Control/Analog module
17 to 32 : Event module
0 41003
Setting area entry register No.
(The 2
nd
word)
0,40000 to 49999 (Note1) 0 41004
.
.
.
Setting area entry St. No.
(The 711
th
word)
0 : Not used
1 to 16 : Control/Analog module
17 to 32 : Event module
0 42421
Setting area entry register No.
(The 711
th
word)
0,40000 to 49999 (Note1) 0 42422
Setting area entry St. No.
(The 712
th
word)
0 : Not used
1 to 16 : Control/Analog module
17 to 32 : Event module
0 42423
Setting area entry register No.
(The 712
th
word)
0,40000 to 49999 (Note1) 0 42424
Note 1: Only the address written in “Setting/Monitor area register number” (Control module
5-51
, Event module
5-64
, Analog module
5-71
) settable. However, the monitor parameters and parameter marked “*” in
the “Entry ban” column cannot be set.