User manual

3 PLC Communication
84 © Copyright Reserved Autonics Co., Ltd.
In case of LS MASTER K200 of CH1, it uses CPU module RS422 port. In case of
MITSUBISHI FX2N for CH2, it uses CPU module RS232 and RS232/422 converter
should be used. If two of RS232C serial interface type, connect RS232/422 converter
at each RS232C A, or RS232C B port.
6th Synchronize the station of between GP/LP and connected devices.
The station of CH1 is available to set from GP/LP. CH2 is set from link device of GP
Editor. (Refer to ‘1.4 Link device’.) For more details, refer to ‘GP Editor user manual’.
7th Synchronize communicate specifications (baudrate, data bit, stop bit, parity, flow
control) of between GP/LP and connected devices by each CH1, CH2.
The communicate specification of downloaded PLC to GP/LP is set as default of the
connected PLC and communication is available directly. (Only when the
communicate specification of connected PLC is set as default)
Touch ‘CH1’ or ‘CH2’ and detailed configuration screen is switched. Designate
detailed configuration by each channel.
8th After completing communication configuration, you should exit system setting menu
and switch user screen to communicate GP Editor with connected devices.
Touch ‘Menu’, current setting values are saved and it returns to previous menu.
Touch ‘Exit’, current setting values are saved and it returns to user