User manual

3 PLC Communication
62 © Copyright Reserved Autonics Co., Ltd.
3.2.3 GP, LP configuration
3.2.3.1 Mono type
Before downloading drawn data from GP Editor: Synchronize communication configurations of
between GP/LP and GP Editor.
After downloading drawn data from GP Editor: After downloading PLC protocol of CH1, CH2
which is designated from GP Editor to GP/LP, it starts communication between the specified PLC
and GP/LP through communication configuration.
1st Enter system setting menu.
Touch left-upper point as default position of system setting menu.
2nd Select [SET ENVIRONMENT]-[PLC SETTING].
3rd CH1 protocol is set as following the designated PLC from GP Editor.
4th To communicate between GP/LP and LS Master-K200 for CH1, desigante the
connect port for the specific PLC and use the dedicated cable. (Refer to ‘4
Communication Cable By Device’)
In case of LS Master-K200, it uses CPU module RS232C port. Set connect port item
of CH1 as ‘RS232C’. Connect port display rotates in order as RS422↔RS232C with
touching.