User manual

3 PLC Communication
60 © Copyright Reserved Autonics Co., Ltd.
7th To communicate between GP/LP and Autonics CT6M-2P for CH2, designate the
connect port for the specific PLC and use the dedicated cable. (Refer to ‘4
Communication Cable By Device’)
In case of Autonics CT6M-2P, it uses RS422 port. Set connect port item of CH2 as
‘RS422’. Connect port display rotates in order as RS422↔RS232C with touching.
8th Synchronize communicate specifications (baudrate, data bit, stop bit, parity, flow
control) of between GP/LP and Autonics CT6M-2P.
The communicate specification of downloaded PLC to GP/LP is set as default of the
connected PLC and communication is available directly. (Only when the communicate
specification of connected PLC is set as default)
Touch ‘SET’ and designate detailed configuration.
9th After completing communication configuration, you should exit system setting menu
and switch user screen to communicate GP Editor.
Touch ‘BEFORE’, current setting values are saved and it returns to previous menu.
Touch ‘CLOSE’, current setting values are saved and it returns to user screen after
exiting system setting menu.