User manual

3 PLC Communication
52 © Copyright Reserved Autonics Co., Ltd.
3.1.2 GP, LP configuration
3.1.2.1 Mono type
Before downloading drawn data from GP Editor: Synchronize communication configurations of
between GP/LP and GP Editor.
After downloading drawn data from GP Editor: After downloading PLC protocol of CH1, CH2
which is designated from GP Editor to GP/LP, it starts communication between the specified PLC
and GP/LP through communication configuration.
1st Enter system setting menu.
Touch left-upper point as default position of system setting menu.
2nd Select [SET ENVIRONMENT]-[PLC SETTING].
3rd CH1 protocol is set as following the designated PLC from GP Editor.
CH1 is designated as LS MASTER-K200 and CH2 is designated as AUTONICS
CT6M-2P from GP Editor.