User manual

6 Connectable PLC
© Copyright Reserved Autonics Co., Ltd. 251
6.13.3 Available device
UB device is as GP/LP inner bit memory, only in GP/LP it is able to use same as general inner
device of PLC.
It is able to switch into word UW device binding 16 units. However it is related with functional
area and it may cause serious error. Be sure to use only within user area UW30 to UW2047
(when not using recipe, UW30 to UW6047).
For further information of GP/LP inner memory, refer to ‘
3.6 System signal’.
Refer to below bit/word available device organization and use the device.
UB 00 0
① Device name ② Word address ③ Bit address
Type
① ② ③
Bit UB Decimal Hexadecimal
Word
M Word address(Decimal)
D Word address(Hexadecimal)
UW Word address(Decimal) None
6.13.3.1 E5AN, E5CN, E5EN
Type Device Mark
Range
Start End
Bit GP/LP inner bit memory UB UB0 UB6047F
Word
Operation command device
※
1
M M0 M0
Variable device
※
2
D D0 D3FFF
GP/LP inner word memory UW UW0 UW6047
6.13.3.2 E5AR, E5ER
Type Device Mark
Range
Start End
Bit GP/LP inner bit memory UB UB0 UB6047F
Word
Operation command device
※
1
M M0 M0
Variable device
※
2
D D0 DFFFF
GP/LP inner word memory UW UW0 UW6047
※1. It is used device when operating command. Enter the specific value, it executes the below
table operation.
※2. Device address is same as each variable of temperature controller. For further details of
each variable, refer to the each product manual.
Command value
(DEC)
Command
description
Executing operation Note
00000
Communication Write
Stops communication write
00001 Allows communication write
00256
RUN/STOP
RUN
00257 STOP
00512 Multi SP Target value 0