User manual

6 Connectable PLC
202 © Copyright Reserved Autonics Co., Ltd.
6.8.2.3 FARA NX7
Device range is different depending on PLC model. Even though same type PLC, there is
difference according to the number of I/O contact point.
Bit device; R, M, K, F, L are not used as general word at PLC. However, it is able to switch into
word UW device binding 16 units in GP/LP.
UB device is as GP/LP inner bit memory, only in GP/LP it is able to use same as general inner
device of PLC.
It is able to switch into word UW device binding 16 units. However it is related with functional
area and it may cause serious error. Be sure to use only within user area UW30 to UW2047
(when not using recipe, UW30 to UW6047).
For further information of GP/LP inner memory, refer to ‘3.6 System signal’’.
Refer to below bit/word available device organization and use the device.
R 00 0
①Device name ②Word address ③Bit address
Type
① ② ③
Note
Bit
R Decimal Decimal(0 to 15)
R##.## of ‘.’ is not
used
M Decimal Decimal(0 to 15)
M##.## of ‘.’ is not
used
K Decimal Decimal(0 to 15)
K##.## of ‘.’ is not
used
F Decimal Decimal(0 to 15)
F##.## of ‘.’ is not
used
L Decimal Decimal(0 to 15)
L##.## of ‘.’ is not
used
TC Bit address(Decimal)
UB Decimal Hexadecimal
Word
R Word address(Decimal) None
M Word address(Decimal) None
K Word address(Decimal) None
F Word address(Decimal) None
L Word address(Decimal) None
PV Word address(Decimal)
SV Word address(Decimal)
W Word address(Decimal)
SR Word address(Decimal)
UW Word address(Decimal) None