User manual

6 Connectable PLC
© Copyright Reserved Autonics Co., Ltd. 201
Word R1 = Bit R100 to R115 , Word UW10 = UB100 to UB10F
There is difference for mark of bit R, M, K, F, L between general mark and GP/LP mark. General
mark is displayed as R##.##, GP/LP mark is displayed without middle of distinguisher.
For example, R10.10 is displayed as ‘R1010’ in G P / L P.
Be sure that GP/LP does not use distinguisher, it uses virtual distinguisher cutting two digits from
the backward of input bit R, M, K, F, L address.
(Ex) Bit R1 = R0.01 , Bit M10 = M0.10 , Bit K101 = K1.01
Type Device Mark
Range
Start
End
Bit
Input relay R R0 R12715
Output relay R R0 R12715
Inner auxiliary relay M M0 M12715
Memory protection relay K K0 K12715
Special relay F F0 F1515
Link relay L L0 L6315
Timer contact[10ms] TC TC0 TC63
Timer contact[100ms] TC TC64 TC255
Counter contact[16bit] TC TC0 TC255
GP/LP inner bit memory UB UB0 UB6047F
Word
Input relay R R0 R127
Output relay R R0 R127
Inner auxiliary relay M M0 M127
Memory protection relay K K0 K127
Special relay F F0 F15
Link relay L L0 L63
Timer present value[10ms] PV PV0 PV63
Timer present value[100ms] PV PV63 PV255
Timer setting value[10ms] SV SV0 SV63
Timer setting value[100ms] SV SV64 SV255
Counter present value[16bit] PV PV0 PV255
Counter setting value[16bit] SV SV0 SV255
Data register
※
1
W W0 W2047
Special register SR SR0 SR511
GP/LP inner word memory UW UW0 UW6047
※1. Depending on CPU type, that range is fluid.
In case of CPL9215A, the range is W0 to W2047. In case of CPL9216A, the range is W0 to
W4095.