Operating instructions

Naming the channels (cont.)
[] Name the Channels
Antenna : A
(Indoor/outdoor)
Channel :---
[] New name : ....
_ DJUST to select
ENTER to enter
I_ MENU to go back
[] Name the Channels
_r_ Antenna : A
(Indoor/outdoor)
Channel :003
]New name : ....
-_ ADJUST to select
ENTER to enter
MENU to go back
O Use the ADJUST bul;tons and
the ENTER button to select
each letter in the new name.
You can use letters (A - Z),
numbers (0 - 9), or s:_lbols (:/.
, ( ) ! "#$ % &'blank+ ;< = > ?
blank - ) for the new name.
If you press the CANCEL
button while setting the name,
you will move one position to
the left. You can clear the
entire name by pressing
CANCEL when the left-most
position is underlined.
When you are finished, press
the HOME button to return to
normal _dewing.
I>Important: The name you set will appear instead of the call letters b.eiag
supplied by Extended Data Services (XDS).
[>Important:
Message "Memory over!" will indicate that the memory i,_fall. If
the memory is full and you want to name a channel, you must use
the above steps to clear the name for an existing channel You can
then select the new channel to name.
Getting Started 65