Operating instructions

AV
Setting the A/V Network
The A/V Network is a system that Mitsubishi developed to make, it
easier to operate many products with one remote control. When
the A/V Network is connected between two Mitsubishi products,
you can point the remote control at t:he television and it will "pa,_s"
the remote control command to the other. In addition to passinG;
the remote control signal, Active A/V Network will .automate the,
TV's input selection and the playback of Mitsubishi VCRs into a
single command. To set up the A/V Network, follow the steps below.
[_]TV Main Menu
First _me Setup
Customize Display
[] Advanced Features
_]Select AiV Memory
[]Guide Plus+ Menu
-------1ADJUST to select
ENTER to enter
MENU to exit menus
[] Set AIM Network
[] o.
[] Basic
[] Active
'--"_ ADJUST to select
!E551 ENTER to enter
I_ MENU to go back
O
O
Press the MENU button on the
remote control. The Main
Menu will appear on the screen.
Use the ADJUST buttons to
select "First Tirae Setup".
Press ENTE_b%XCH.
Use ADJUST to select "Set t_V
Network", then press ENTER]
EXCH.
O Use the ADJUST buttons to
select "Active" ,"Basic", or "()iT'.
Check the rear terminals of
your VCR, the_. use the cha_t
below to deternfine how you
should set your TV.
If your VCR has a rear ...and you have set your ...then set your TV to:
terminal that reads: VCR to:
Basic
A/V Network
Active A/V Network Off Basic
Active AJV Network Active Active
Does not have an A/V -- Off
Network rear terminal
:'::7:'--:,:: :.:: :-.Tz:'.
_>Important:
[}>Important:
E>Important:
OPress the ENTER/EXCH or MENU button to return to the
"First Time Setup" menu. Press HOME to exit all menus.If
you are not sure how to set your VCR's A/V Network setting,
refer to your VCR's owner's guide.
The A/V Network can still be used to pass remote control signals
even when the TV's "A/V Network" setting is "Off'.
If you do not use the A/V Network system, set "A!V Network" to
"Off'. If you don't, channel selection may not work correctly.
If you select Active or Basic A/V settings, make sure your Mitsub-
ishi VCR with an A/V Network or Active A/V Network connection is
connected to Input-1 and the AiV network cable is in place.
60 Chapter 3: Operating Your TV