Operating instructions

Using the remote control to operate VCRs, cable
boxes and other components (cont.)
setting up the remote control to operate your V,CR
0
0
O
Turn offyour VCR.
Set the select switch on the remote to choose the layer you
want to set up: VCR-A or DVD.
While holding in the POWER button on the remol;e control,
enter the code number listed in the chart below for your brand
of VCR. Be sure to enter both digits of the code number. If
more than one number is listed, begin with the first one.
O Release the POWER button.
If your VCR
is this brand...
Mitsubishi (A)
Mitsubishi (B)
Canon
Emerson
Funai
General Electric
Goldstar
Hitachi
JVC
...enterthis
code
01
02
03
04, 05
06
03
07
08
09
If your VCR
isthis brand...
Magnavox
Murtitech
NEC
Panasonic
Philco
Philips
Quasar
RCA
Sanyo
...enterthis
code
03, 10, 11
06
12
O3
03, 10
03, 10, 11
03
08, 13, 20
14
I1:your VCR
is[hisbrand...
Scot
Sharp
Sony
Sylvania
Symphonic
Teknika
Toshiba
Totevision
Zenith
...enterthis
code
15
16
77, 18
03, 10, 11
06
_o4,06
15
O7
19
O Press the POWER button again. Your VCR should turn on. If
the VCR turns on, your remote control is ready to operate your'
VCR. If your VCR does not turn on, repeat the instructions
trying each code number from 01 to 30.
using remote control to operate your VCR
After you have set up your remote control for your particular brand
of VCR, you can use the remote to operate your VCR.
O
Set the select switch on the remote control to the layer that you
set up to operate your VCR: VCR-A or DVD.
Point the remote control at the VCR and press the desired
buttons.
If you are using a Mitsubishi VCR, you will be able to use all of the
buttons on the remote control to operate your VCR except for
MUTE, VOLUME and the PIP function buttons, which will always
operate the TV itself.
If you are using another brand of VCR, you can use the POWER,
CHANNEL, REC, STOP, Pause, REW, PLAY, and FF buttons to
operate your VCR.
Getting Started 43