Operating instructions

TV + VCR + antenna or cable with a cable box
(cont.)
procedure
_>Important:
Important:
_' Important:
O Connect the incoming cable to the ANT-A terminal on the back
of the TV.
O
Connect a coaxial cable from the CABLE LOOP-OUT terminal[
on the back of the TV to the cable box IN terminal.
O Connect a second cable from the OUT terminal on the cable box
to the ANTENNA IN terminal on the back of the VCR.
0 Connect a third coaxial cable from the ANTENNA OUT termi-
nal on the back of the VCR to the ANT-B terrainal on the back
of the TV.
Connect an RCA pin-type video cable from the VIDEO OUT
terminal on the back of the VCR to the VIDEO INPUT termi-
nal on the back of the TV.
If you are connecting a Super VHS (S-VHS) VCR, use an S-Video
cable instead of an RCA pin-type _rideo cable. Connect this S-Video
cable to the S-VIDEO OUT terminal on the VCR. Connect the
other end of this cable to the S-VIDEO INPUT terminal on the
back of the TV.
O
Connect a set of RCA pin-type audio cable_,; to the AUDIO OUT
terminals on the back of the VCR. Use the red cable to connect
the right (R) channel and the white cable to ,mnnect the left (L)
channel.
Connect the other ends of this cable to the AUDIO INPUT
terminals on the back of the TV.
If your VCR is monaural (non-stereo), you only need to connect a
single RCA pin-type audio cable. Connect the cable to the audio
out terminal of the VCR, then connect the other end to the left (L)
audio input on the back of the TV.
If your VCR has a video channel switch, set it to "OFF/AV". See
your VCR owner's guide for details.
34 Chapter 2: Connecting Your TV