Operating instructions

TV+cable with a decoder box
equipment you will need
Use this hook-up if you need a decoder box to descramble cable
signals. This hook-up will allow you to use your TV's remote control
to change channels through the decoder box, if the cable layer of the
remote control is set up to do so (See "Using the remote control" on
page 42).
To complete the hook-up, you'll need:
• I length of 75 ohm coaxial
cables.
Procedure
O Connect the incoming cable to the IN terminal on the decoder
box.
Connect a coaxial cable to the OUT terminal on the decoder box;
connect the other end of this cable to the antenna terminal on
the back of the TV.
Incoming Cable
IN
Cable Decoder Box
Rear Terninals
75 Ohm
Coaxial Cable
@
TV rear terminals
VHF/UHI:
@
p _ S-V
O 0
--O-
ooll oo,,
o
Basic Connections 29