Operating instructions

Important:
Important:
Important:
procedure
(See illustration on the following page.)
O Connect the incoming cable or antenna to the ANTENNA IN
terminal on the VCR.
O Connect one end of a coaxial cable to the ANTENNA OUT
terminal on the VCR.
Connect the other end of the coaxial cable to the antenna
terminal on the TV.
O Connect an RCA pin-type video cable to the VIDEO OUT
terminal on the back of the VCR. Connect the other end of this
cable to the VIDEO INPUT terminai_ or, the back of tlhe televi-
sion.
If you are connecting a Super VHS (S-VHS) VCR, use an S-Video
cable instead of an RCA pin-type vide,) cable. Connect this S-Video
cable to the S-VIDEO OUT terminal cn the VCR. Connect the other
end of this cable to the S-VIDFO INPUT terminal on the back of
the TV.
O
Connect a set of RCA pin-type audio cables to the AUDIO OUT
terminals on the back of the VCR. Use the red cable to connect
the right (R) channel and _he whi_e cable for connecting the left
(L) channel.
Connect the other ends of these cabtes to the AUDIO INPUT
terminals on the back of the TV.
If your VCR is monaural (non.-stereo), you only need to connect a
single RCA pin-type audio cable. Connect 1:;hecable to the VCR,
then connect the other end to the L (LEFT) audio input on the back
of the TV.
If your VCR has a video channel switch, set it to "OFF!AV." See
your VCR's owner's guide for details.
Start playing a tape on your VCR.
Use the INPUT button on your TV's remote control to select
Input-1.
Basic Connections 29