Operating instructions

TV + cable with a decoder box
equipment you will need
Use this hook-up if you need a decoder box to descramble cable
channels. When you complete this hook-up, you should set up your
remote control to operate your cable box (see page 37).
To complete the hook-up, you'll need:
• One length of 75 ohm coaxial
cable.
procedure
O Connect the incoming cable to
the IN terminal on the decoder
box.
O Connect the coaxial cable to the OUT terminal on the back of
the decoder box; connect the other end of this cable to the
antenna terminal on the back of the TV.
Incoming Cable
I
O Cable Decoder Box
Rear Terminals
<)
0
-[-V Rear Terminals
VHFfJH_
(75_)
----. @)
26 Chapter 2: Connecting Your TV