Operating instructions

TV + VCR + antenna or cable with a cable ]box
(cont.)
[:>Important:
[::>Important:
Connect the IR emitter cable to the I:EUGLINK. Place one of
the emitter ends in front of the cable box. Place the other
emitter end in front of the VCR. For more detail concerning
the placement of the emitter lenses, see the TV GUIDE Plus+
Operating Guide.
If your VCR is monaural (non-stereo), you only need to connect a
single RCA pin-type audio cable. Connect the cable to the audio
out terminal of the VCR, then connect the ether end to tlhe L (left)
audio input on the back of the TV.
If your VCR has a video channel switch, set; it to "OFF/AV _'. See
your VCR owner's guide for details.
VCR Rear Terminals
Y"O
I S-VlOEO
TV Rear Terminals
o
(75 £}
@ t[[o)} _[LI,)_ 2
® @........
o
Cable Box
Rear Terminals
IR EmitLer
32 Chapter 2: Connecting Your TV