Operating instructions

Overview of the back panel (cont.)
@
antenna terminals (ANT-A, CABLE LOOP-OUT, ANT-B)
Two independent cables or antenaas can be connected to these
terminals. Use ANT-A and ANT-B terminals to receive a
signal from VHF/UHF antennas or your cable system. Use the
CABLE LOOP OUT terminal to send the s:Lgnal being received
by the ANT-A terminal out to another component (such as a
VCR).
IThe TV GUIDE Plus+ signal source MUST be connected to the
ANT-A terminal.
_>Important:
(_) S-VIDEO input terminal
Use these terminals to connect an S-video signal from a Super
VHS (S-VHSI VCR or disc player to the TV.
If you connect to the S-Video jack, you cannot use the regular video
jack for the same input.
(_) video input terminals
Use these terminals to connect the video output from a stan-
dard VCR or other component to the TV.
®
@
®
®
®
®
audio input terminals
Use these terminals to connect the audio output from a VCR or
other component to the TV.
IR/G link
Use this terminal to connect; an Infrared (IR) Emitter for TV
GUIDE Plus+ cable box and VCR control features. NOTE: TV
GUIDE Plus+ system can only operate the type of VCRs and
cable boxes that can select channels using a remote conl:rol
with a number keypad.
active A/V Network terminal
Use this terminal to connect; a Mitsubishi VCR that has an AiV
network terminal.
video output terminal
Use this terminal to send the TV video s_gnal to a VCR, A/V
receiver or other component.
audio output terminals
Use these terminals to send the TV's audio signal to a VCR,
A/V receiver, or other component.
color purity adjustment switches (CS-36509 only)
Set these switches according to the placement and position of
your TV. See "Adjusting the Color Purity" in Chapter 3.
Overview of the Back Panel 21