Operating instructions

Using the remote control to operate VCRs, cable
boxes and other components (cont.)
using your remote control to operate your cable box or
satellite box
After you have set up your remote control for your particular brand
of cable or satellite box, you can use the remote to operate it.
O Use the select switch on the remote control to choose the layer
that you set up to operate your cable o:: satellite box: AUDIO
or DVD.
O Point the remote control[ at the cable o:_satellite box and press
the desired buttons.
You can use the POWER, CHANNEL, nambers (0-9), and :ENTER
buttons to operate your cable box. If you are using an RCA DSS or
PRIMESTAR ® receiver, you. may be able to use additional buttons.
Refer to the instructions for these device,s.
setting up the remote control to operate your Mitsubishi
disc player or AN receiver
q[]} Turn off your audio component.
Set the select switch on the top of the remote to choose the
layer you want to set up. For a laserdisc player, choose DVD or
AUDIO. For an A/V receiver, choose AUDIO or TV.
While holding in the POWER button on the remote control,
enter one of these code numbers:
For a
35 or
For a
For a
For a
Mitsubishi A/V receiver and compact disc player: 30, 31,
38
Mitsubishi and some Pioneer laserdisc players: 3:2 or 33
Yamaha A/V receiver and compact disc player: 36 or 37
Mitsubishi DVD player: 34
Be sure to enter both digits of the code number. Start ,_th the
first code listed.
O Release the POWER button.
O Press the POWER button again. Your disc player or audio
component should turn on. If it doe,;, your remote c,ontrol is
now set up to operate your audio component. If it does not turn
on, repeat the instructions above, trying the next code number
listed for your component.
See the next page for information on using the remote to
operate your A/V components.
38 Chapter 3: Operating Your TV