Specifications

CC-Link Configuration Example for MELSEC System Q
3 - 18
MITSUBISHI ELECTRIC
3.3 Configuration Example for MELSEC System Q
For this example, a CC-Link slave consisting of the following STlite modules is used:
– Head station STL-BT1
– Digital input module STL-DI8-V1 (8 inputs)
– Digital output module STL-DO4 (4 outputs)
– Analog output module STL-DA4-V1 (4 channels, 0 to 10 V)
– Analog input module STL-AD2-V (2 channels, 0 to 10 V)
–End module STL-ET
3.3.1 Settings for the Master Station
In this example, a QJ61BT11N is used as master station for the CC-Link. The station number is set to "0"
and the mode switch to "4" for a transmission speed of 10 Mbit/s.
NOTE
For the specifications of the modules and the installation procedures please refer to the installa-
tion manual of the STlite series.
STlite modules with power contacts (male contacts) cannot be linked to bus modules with fewer
power contacts. In this case install a power supply module between the two relevant modules.
Fig. 3-16: Station number and transmission
speed selector switches of the
QJ61BT11N
Station number: 0
x10 = 0
x1 = 0
Transmission
speed: 10 Mbit/s
MODE = 4