Specifications

II Parameters

User Parameters

II - 12

【#8216】 Type in G28 return

Select the performance after establishing the reference position in reference position return

command.

0: Moves to the reference position.

1: Won't move to the reference position.

【#8217】 Check start point

Set a drawing start position in graphic check of each axis.

---Setting range---

-99999.999 to 99999.999 (mm)

【#8218】 Dir cmd retrct amt

Set in which direction and how much the tool escapes when the operation is halted during

direct command mode. (Radius value)

The tool does not escape when "0" is set.

---Setting range---

-99999.999 to 99999.999 (mm)

【#8219】 Hob retract amount 1

Set the retract amount using the radius value when the Hob retract amount selection signal

is OFF.

Retract is carried out in the negative direction if a negative value is set.

---Setting range---

-99999.999 to 99999.999 (mm)

【#8220】 Hob retract amount 2

Set the retract amount using the radius value when the Hob retract amount selection signal

is ON.

Retract is carried out in the negative direction if a negative value is set.

---Setting range---

-99999.999 to 99999.999 (mm)

【#8221】 Hob retract speed

Set the retract speed during hobbing.

---Setting range---

1 to 1000000 (mm/min)

【#8300】 P0 (for L system only)

Set the reference X-coordinates of the chuck and the tail stock barrier.

Set the center coordinate (radius value) of workpiece by the basic machine coordinate

system.

---Setting range---

-99999.999 to 99999.999 (mm)

【#8301】 P1 (for L system only)