Specifications

II Parameters
User Parameters
II - 7
【#8083】 G83S modeM (for M system only)
Set the M command code for changing to the small diameter deep hole drilling cycle mode.
---Setting range---
1 to 99999999
【#8084】 G83S Clearance (for M system only)
Set the clearance amount for the small diameter deep hole drilling cycle (G83).
---Setting range---
0 to 999.999 (mm)
【#8085】 G83S Forward F (for M system only)
Set the feedrate from the R point to the cutting start position in the small diameter deep hole
drilling cycle (G83).
---Setting range---
0 to 99999 (mm/min)
【#8086】 G83S Back F (for M system only)
Set the speed for returning from the hole bottom during the small diameter deep hole drilling
cycle (G83).
---Setting range---
0 to 99999 (mm/min)
【#8090】 SSS ON (for M system only)
Set whether to enable the SSS control with G05 P10000.
0: Disable
1: Enable
【#8091】 StdLength (for M system only)
Set the maximum value of the range for recognizing the shape.
To eliminate the effect of steps or errors, etc., set a large value. To enable sufficient
deceleration, set a small value.
If "0.000" is set, the standard value (1.000mm) will be applied.
---Setting range---
0 to 100.000 (mm)
【#8092】 ClampCoeff (for M system only)
Set the clamp speed at the curved section configured of fine segments.
Coefficient = √ setting value
---Setting range---
1 to 100
【#8093】 StepLeng (for M system only)
Set the width of the step at which the speed is not to be decelerated. (Approximately the
same as the CAM path difference [Tolerance].)
If "0" is set, the standard value (5μm) will be applied.
If a minus value is set, the speed will decelerate at all minute steps.
---Setting range---
-1.000 to 0.100 (mm)
【#8094】 DccWaitAdd (for M system only)
Set the time to wait for deceleration when the speed FB does not drop to the clamp speed.
---Setting range---
0 to 100 (ms)
【#8101】 MACRO SINGLE
Select how to control the blocks where the user macro command continues.
0: Do not stop while macro blocks continue.
1: Stop every block during signal block operation.
【#8102】 COLL. ALM OFF
Select the interference (bite) control to the workpiece from the tool diameter during tool
radius compensation and nose R compensation.
0: An alarm will be output and operation stops when an interference is judged.
1: Changes the path to avoid interference.
【#8103】 COLL. CHK OFF
Select the interference (bite) control to the workpiece from the tool diameter during tool
radius compensation and nose R compensation.
0: Performs interference check.
1: Does not perform interference check.
【#8105】 EDIT LOCK B
Select the edit lock for program Nos. 8000 to 9999 in the memory.
0: Enable the editing.
1: Prohibit the editing of above programs.
When "1" is set, the file cannot be opened.