Specifications

I Alarms
Program Errors (P)
I - 66
P191 Taper length error
Details
In the lathe cutting cycle, the specified length of taper section is illegal.
Remedy
- Set the smaller radius value than the axis travel amount in the lathe cycle command.
P192 Chamfering error
Details
Chamfering in the thread cutting cycle is illegal.
Remedy
- Set a chamfering amount not exceeding the cycle.
P200 No spec: MRC cycle
Details
The compound type fixed cycle for turning machining I (G70 to G73) was commanded though
it is out of specifications.
Remedy
- Check the specifications.
P201 Program error (MRC)
Details
- The subprogram, called with a compound type fixed cycle for turning machining I command,
has at least one of the following commands: reference position return command (G27, G28,
G29, G30); thread cutting (G33, G34); fixed cycle skip-function (G31, G31.n).
- An arc command was found in the first movement block of the finished shape program in
compound type fixed cycle for turning machining I.
Remedy
- Delete G27, G28, G29, G30, G31, G33, G34, and fixed cycle G codes from the subprogram
called with the compound type fixed cycle for turning machining I commands (G70 to G73).
- Delete G02 and G03 from the first movement block of the finished shape program in com-
pound type fixed cycle for turning machining I.
P202 Block over (MRC)
Details
The number of blocks in the shape program of the compound type fixed cycle for turning ma-
chining I is over 50 or 200 (the maximum number differs according to the model).
Remedy
- Set a 50/200 or less value for the number of blocks in the shape program called by the com-
pound type fixed cycle for turning machining I commands (G70 to G73). (The maximum
number differs according to the model).
P203 D cmnd figure error (MRC)
Details
A proper shape will not obtained by executing the shape program for the compound type fixed
cycle for turning machining I (G70 to G73).
Remedy
- Correct the shape program for the compound type fixed cycle for turning machining I (G70
to G73).
P204 E cmnd fixed cycle error
Details
A command value of the compound type fixed cycle for turning machining (G70 to G76) is il-
legal.
Remedy
- Correct the command value of the compound type fixed cycle for turning machining (G70 to
G76).
P210 No spec: Pattern cycle
Details
A compound type fixed cycle for turning machining II (G74 to G76) command was commanded
though it is out of specifications.
Remedy
- Check the specifications.
P220 No spec: Special fixed cycle
Details
There are no special fixed cycle specifications.
Remedy
- Check the specifications.
P221 No. of special fixed holes = 0
Details
"0" has been specified for the number of holes in special fixed cycle mode.
Remedy
- Correct the program.
P222 G36 angle error
Details
A G36 command specifies "0" for angle intervals.
Remedy
- Correct the program.
P223 G12/G13 radius error
Details
The radius value specified with a G12 or G13 command is below the compensation amount.
Remedy
- Correct the program.
P224 No spec: Circular (G12/G13)
Details
There are no circular cutting specifications.
Remedy
- Check the specifications.