Specifications

I Alarms
Program Errors (P)
I - 62
P112 Plane selected while R compen
Details
- Plane selection commands (G17, G18, G19) were issued while tool radius compensation
(G41, G42) and nose R compensation (G41, G42, G46) commands were being issued.
- Plane selection commands were issued after completing nose R compensation commands
when there were no further axis movement commands after G40, and compensation has not
been cancelled.
Remedy
- Issue plane selection commands after completing (axis movement commands issued after
G40 cancel command) tool radius compensation and nose R compensation commands.
P113 Illegal plane select
Details
The circular command axis does not correspond to the selected plane.
Remedy
- Select a correct plane before issuing a circular command.
P120 No spec: Feed per rotation
Details
Feed per rotation (G95) was commanded though it is out of specifications.
Remedy
- Check the specifications.
P121 F0 command during arc modal
Details
F0 (F 1-digit feed) was commanded during the arc modal (G02/G03).
Remedy
- Correct the machining program.
P122 No spec: Auto corner override
Details
An auto corner override command (G62) was issued though it is out of specifications.
Remedy
- Check the specifications.
- Delete the G62 command from the program.
P123 No spec: High-accuracy control
Details
High-accuracy control command was issued though it is out of specifications.
Remedy
- Check the specifications.
P124 No spec: Inverse time feed
Details
- The inverse time option is not provided.
Remedy
- Check the specifications.
P125 G93 mode error
Details
- The issued G code command is illegal during G93 mode.
- G93 command was issued during a modal for which inverse time feed cannot be performed.
Remedy
- Correct the program.
P126 Invalid cmnd in high-accuracy
Details
An illegal command was issued during the high-accuracy control mode.
- A G code group 13 command was issued during the high-accuracy control mode.
- Milling, cylindrical interpolation or pole coordinate interpolation was commanded during the
high-accuracy control mode.
Remedy
- Correct the program.
P127 No spec: SSS Control
Details
The SSS control valid parameter has been set although there is no SSS control specification.
Remedy
- Check the specifications. Set "#8090 SSS ON" to "0" when there is no SSS control specifi-
cation.
P128 Machin condtn select I disable
Details
Machining condition selection I was commanded during the mode where the selection com-
mand is unavailable.
Remedy
- Check the program and see whether any unavailable mode is included during machining
condition selection I. If any, cancel that mode.
P130 2nd M function code illegal
Details
The 2nd miscellaneous function address, commanded in the program, differs from the ad-
dress set in the parameters.
Remedy
- Correct the 2nd miscellaneous function address in the program.
P131 No spec: Cnst surface ctrl G96
Details
A constant surface speed control command (G96) was issued though it is out of specifications.
Remedy
- Check the specifications.
- Issue a rotation speed command (G97) instead of the constant surface speed control com-
mand (G96).