Specifications

I Alarms
Stop Codes (T)
I - 14
T01 Cycle st prohibit(Battery alm) 0116
Details
Automatic start is not possible because the voltage of the battery in the NC control unit has
dropped.
Remedy
- Replace the battery of the NC control unit.
- Contact the service center.
T01 R-pnt offset value not set 0117
Details
Automatic operation is not possible because no reference position offset value has been set.
Remedy
- Perform the reference position initialization setting, then set "#2034 rfpofs(Distance-coded
reference position detection offset)".
T01 Cycle start prohibit 0118
Details
Tool retract position signal OFF
The axis was moved from the tool retract position. Tool retract position reached signal is OFF.
Remedy
Once the axis has been moved off the tool retract position, resuming the program is not pos-
sible. Cancel the program by reset and then execute it from the start.
T01 In absolute position alarm 0138
Details
A start signal was input during an absolute position detection alarm.
Remedy
- Clear the absolute position detection alarm, and then input the start signal.
T01 In abs posn initial setting 0139
Details
A start signal was input during zero point initialization in the absolute position detection sys-
tem.
Remedy
- Complete zero point initialization before inputting the start signal.
T01 Start during MDI operation at other part system disable 0141
Details
In multi-part system, a start signal was input for MDI mode while the MDI operation was being
carried out in another part system.
Remedy
- End the other part system's operation before starting.
T01 Cycle start prohibit 0142
Details
In manual coordinate system setting
Automatic start is not allowed during the manual coordinate system setting.
Remedy
The system restarts after either of the manual coordinate system setting completion signal or
the error end signal has been turned ON.
T01 In manual measurement 0143
Details
Automatic start is disabled because manual measurement is in execution.
Remedy
- Execute automatic start after the manual measurement is completed.
T01 APLC password mismatch 0160
Details
The APLC authentication password is inconsistent.
Remedy
- Contact the machine tool builder.
T01 Cycle start prohibit 0180
Details
Automatic start became disabled while servo auto turning is enabled.
Remedy
- Set "#1164 ATS" to "0" when the servo auto turning is not executed.
T01 Cycle start prohibit 0190
Details
Automatic start is not possible because the setting of setup parameters is enabled.
Remedy
- Refer to the manual issued by the machine tool builder.
T01 Cycle start prohibit 0191
Details
Automatic start was attempted while a file was being deleted/written.
Remedy
- Wait for the file to be deleted/written and then execute the automatic start.
T01 Cycle st. prohibit (Term exp'd) 0193
Details
Automatic start is not possible because the valid term has been expired.
Remedy
- Obtain a decryption code from the machine tool builder and input it in the NC, then turn the
power ON again.
T02 H/W stroke end axis exists 0201
Details
An axis is at the stroke end.
Remedy
- Manually move the axis away from the stroke end limit switch.
- Correct the machining program.