Specifications

II Parameters
Axis Specifications Parameters
II - 115
【#2090】 plrapid Rapid traverse rate for super-imposition control
Set the rapid traverse rate for superimposition control.
(Equivalent to "#2001 rapid Rapid traverse rate".)
---Setting range---
1 to 1000000 (mm/min)
【#2091】 plclamp Cutting feed clamp speed for super-imposition control
Set the cutting feed clamp speed for superimposition control.
(Equivalent to "#2002 clamp Cutting feed clamp speed".)
---Setting range---
1 to 1000000 (mm/min)
【#2092】 plG0tL G0 time constant for superimposition control (linear)
Set the G0 time constant (linear) for superimposition control.
(Equivalent to "#2004 G0tL G0 time constant (linear)".)
---Setting range---
1 to 4000 (ms)
【#2093】 plG0t1 G0 time constant for superimposition control (primary delay)
Set the G0 time constant (primary delay) for superimposition control.
(Equivalent to "#2005 G0t1 G0 time constant (primary delay".)
---Setting range---
1 to 5000 (ms)
【#2094】 plG1tL G1 time constant for superimposition control (linear)
Set the G1 time constant (linear) for superimposition control.
(Equivalent to "#2007 G1tL G1 time constant (linear)".)
---Setting range---
1 to 4000 (ms)
【#2095】 plG1t1 G1 time constant for superimposition control (primary delay)
Set the G1 time constant (primary delay) for superimposition control.
(Equivalent to "#2008 G1t1 G1 time constant (primary delay)".)
---Setting range---
1 to 5000 (ms)
【#2096】 crncsp Minimum corner deceleration speed
Set the minimum clamp speed for corner deceleration in the high-accuracy control mode.
Normally set "0".
(Note) This parameter is invalid during SSS control.
---Setting range---
0 to 1000000 (mm/min)
【#2097】 tlml2- Sub side tool setter - direction sensor
Set the sensor position (on sub side) in the (-) direction when using the tool setter on the
sub spindle side.
(Note) In the case of the basic axis and inclined axis of the inclined axis specifications, set
the position on the orthogonal coordinate.
---Setting range---
-99999.999 to 99999.999 (mm)
【#2098】 tlml2+ Sub side tool setter + direction sensor
Set the sensor position (on sub side) in (+) direction when using the tool setter on the sub
spindle side.
(Note) In the case of the basic axis and inclined axis of the inclined axis specifications, set
the position on the orthogonal coordinate.
---Setting range---
-99999.999 to 99999.999 (mm)
【#2102】 skip_tL Skip time constant linear
Set a linear control time constant for variable speed skip acceleration and deceleration, or
for an occasion where a skip command issues acceleration/deceleration time constant
enabled (R1).
The time constant will be enabled when LC (cutting feed with linear acceleration and
deceleration) or "F" (soft acceleration/deceleration) is selected in "#2003 smgst
Acceleration and deceleration modes".
When set to "0", the time constant set by "#2008 G1t1" is used.
---Setting range---
0 to 4000 (ms)