Specifications

II Parameters
Axis Specifications Parameters
II - 114
【#2076】 index_x Index table indexing axis
Select whether the axis is a normal axis or an index table indexing axis.
0: Normal axis
1: Index table indexing axis
(Note) This parameter is valid only for the NC axis. The parameter is invalid if set for the
PLC axis.
【#2077】 G0inps G0 in-position width
Set the in-position width for G0.
Between SV024 and this parameter, the parameter with a larger value will be applied.
When "0" is set, this parameter will be invalid: only SV024 will be available.
---Setting range---
0.000 to 99.999 (mm)
【#2078】 G1inps G1 in-position width
Set the in-position width for G1.
Between SV024 and this parameter, the parameter with a larger value will be applied.
When "0" is set, this parameter will be invalid: only SV024 will be available.
---Setting range---
0.000 to 99.999 (mm)
【#2079(PR)】 chcomp Chopping compensation coefficient
Set the coefficient to be applied to the compensation amount for the insufficient amount
caused by servo delay during chopping.
---Setting range---
0 to 10 (standard value: 8)
【#2080】 chwid Bottom dead center position width
Set the tolerance between the commanded stroke and actual stroke.
Compensation will be applied during chopping so that the result of [command width -
maximum stroke of top or bottom dead point/ 2] will be within this tolerance.
---Setting range---
0 to 10.000 (mm)
【#2081】 chclsp Maximum chopping speed
Set the clamp speed in chopping operation.
When "0" is set, the clamp speed will be determined by "#2002 clamp".
---Setting range---
0 to 60000 (mm/min)
【#2082】 a_rstax Restart position return order
Set the No. for each axis in order from the 1st automatically returning axis to the restart
position.
When "0" is set, the axis will not return.
Note that when "0" is set for all axes, all of the axes will return simultaneously.
---Setting range---
0 to 8
【#2084】 G60_ax Unidirectional positioning operation selection
Select how to operate the unidirectional positioning when the positioning command (G00) is
issued.
0: Carry out unidirectional positioning according to the command and modal.
1: Carry out unidirectional positioning regardless of the command and modal.
Set "1" for the axis to carry out the unidirectional positioning at every positioning command,
regardless of whether the unidirectional positioning command and modal are issued.
<Related parameters>
"#8209 G60 SHIFT" and "#2076 index_x"
【#2087】 syncnt Synchronization/super-imposition control setting for each axis
Set the polarity of synchronous axis with respect to basic axis to the bit corresponding to
each axis.
0: Polarity with respect to basic axis is positive
1: Polarity with respect to basic axis is negative
---Setting range---
0 to FF (hexadecimal)
【#2088】 bsax_sy Reference axis for synchronous control
Set the basic axis for synchronous control with the 2nd axis name (axname2).A numerical
character cannot be set as the 1st character.
---Setting range---
Axis name
【#2089】 bsax_pl Superimposition control base axis
Set the base axis of superimposition control using the 2nd axis name (axname2).
A numerical character cannot be set as the 1st character.
(Note) This parameter is enabled only when "#1280 ext16/bit7 Control axis superimposition
command method" is set to "1".
---Setting range---
A to Z and 1 to 9 (Two digits)
(Setting will be cleared when "0" is set)