Specifications

II Parameters
Base Specifications Parameters
II - 94
【#1523】 C_feed Normal line control axis turning speed
Set the turning speed of the normal line control axis at the block joint during normal line
control.
Set a value that does not exceed the normal line control axis' clamp speed ("#2002 clamp").
This is valid with normal line control type I.
---Setting range---
0 to 1000000 (°/min)
【#1524】 C_type Normal line control type
Select the normal line control type.
0: Normal line control type I
1: Normal line control type II
【#1533】 millPax Pole coordinate linear axis name
Set the linear axis name used for pole coordinate interpolation.
---Setting range---
Axis name such as X, Y or Z
【#1534】 SnG44.1 Spindle No. for G44.1 command
Set the selected spindle No. for the G44.1 command.
The setting range differs according to the model.
If a spindle that does not exist is set, the 2nd spindle will be used. Note that if there is only
one spindle, the 1st spindle will be used.
0: 2nd spindle
1: 1st spindle
2: 2nd spindle
3: 3rd spindle
4: 4th spindle
5: 5th spindle
6: 6th spindle
【#1535】 C_leng Minimum turning movement amount
Set the minimum turning movement amount of the normal line control axis at the block joint
during normal line control.
---Setting range---
0.000 to 99999.999 (mm) (Input setting increment applies)
【#1537】 crsax[1] Mixed control (cross axis control) axis
Set the axis to be interchanged during the mixed control (cross axis control).
Using two digits, set the name of the axis to be interchanged with the axis in the part system
where the mixed control (cross axis control) request signal is input, or the name of the axis
to be shifted to that part system.
---Setting range---
Two digits between A to Z and 1 to 9
(Setting will be cleared when "0" is set)
【#1538】 crsax[2]
Set the axis to be interchanged during the mixed control (cross axis control).
Using two digits, set the name of the axis to be interchanged with the axis in the part system
where the mixed control (cross axis control) request signal is input, or the name of the axis
to be shifted to that part system.
---Setting range---
Two digits between A to Z and 1 to 9
(Setting will be cleared when "0" is set)
【#1539】 crsax[3]
Set the axis to be interchanged during the mixed control (cross axis control).
Using two digits, set the name of the axis to be interchanged with the axis in the part system
where the mixed control (cross axis control) request signal is input, or the name of the axis
to be shifted to that part system.
---Setting range---
Two digits between A to Z and 1 to 9
(Setting will be cleared when "0" is set)
【#1540】 crsax[4]
Set the axis to be interchanged during the mixed control (cross axis control).
Using two digits, set the name of the axis to be interchanged with the axis in the part system
where the mixed control (cross axis control) request signal is input, or the name of the axis
to be shifted to that part system.
---Setting range---
Two digits between A to Z and 1 to 9
(Setting will be cleared when "0" is set)
【#1541】 crsax[5]
Set the axis to be interchanged during the mixed control (cross axis control).
Using two digits, set the name of the axis to be interchanged with the axis in the part system
where the mixed control (cross axis control) request signal is input, or the name of the axis
to be shifted to that part system.
---Setting range---
Two digits between A to Z and 1 to 9
(Setting will be cleared when "0" is set)