Specifications

II Parameters
Base Specifications Parameters
II - 93
【#1511】 DOORPm Signal input device 1 for door interlock II: for each part system
Set the fixed device number (X??) for door interlock II signal input for each part system.
A device number from X01 to XFF can be specified.(Except X100.)
Device number "000" is invalid.
Set device number "100" when using no fixed device number for door interlock II signal
input.
Related parameter: "#1154 pdoor (Door interlock II for each part system) "
---Setting range---
000 to 2FF (hexadecimal)
【#1512】 DOORPs Signal input device 2 for door interlock II: for each part system
Set the fixed device number (X??) for door interlock II signal input for each part system.
(Set the same value as that of #1155.)
Related parameter: "#1154 pdoor (Door interlock II for each part system)"
---Setting range---
000 to 2FF (hexadecimal)
【#1513】 stapM M code for synchronous tap selection
Set the M code for the synchronous tapping selection.
Select the synchronous tapping mode using the miscellaneous function code of the value
set in this parameter. The M function command can be issued immediately before the tap
command or in the same block. This function is valid only when "1" is set in "#1272 ext08/
bit1 (Enable/disable M-function synchronous tap cycle)".
(Note) Do not use M00, 01 02, 30, 98, and 99.
---Setting range---
0 to 99999999
【#1514】 expLinax Exponential function interpolation linear axis
Set the axis name for the linear axis used in exponential function interpolation.
---Setting range---
A to Z
【#1515】 expRotax Exponential function interpolation rotary axis
Set the axis name for the rotary axis used in exponential function interpolation.
---Setting range---
A to Z
【#1516】 mill_ax Milling axis name
Set the name of the rotary axis used in milling interpolation. Only one rotary axis can be set.
When there is no E command in issuing the G12.1 command, this parameter will be
followed.
---Setting range---
A to Z
【#1517】 mill_C Milling interpolation hypothetical axis name
Select the hypothetical axis command name for milling interpolation.
When there is no D command in issuing the milling interpolation command, this parameter
will be followed.
0: Y axis command
1: Command rotary axis name.
【#1518】 polm Spindle-spindle polygon Workpiece spindle No.
Set the workpiece axis No. used in spindle-spindle polygon machining.
(Note) The 1st spindle will be selected when "0" is set.
【#1519】 pols Spindle-spindle polygonTool spndle No.
Set the number of the rotary tool spindle used in spindle-spindle polygon machining.
(Note) The 2nd spindle will be selected when "0" is set.
【#1520(PR)】 Tchg34 Additional axis tool compensation operation (for L system only)
Select axis to carry out the additional axis' tool compensation function.
0: 3rd axis.
1: 4th axis.
【#1521】 C_min Minimum turning angle
Set the minimum turning angle of the normal line control axis at the block joint during normal
line control.
---Setting range---
0.000 to 360.000 (°) (Input setting increment applies)
【#1522(PR)】 C_axis Normal line control axis
Set the number of the axis for normal line control.
Set a rotary axis No.
0: Normal line control disabled
1 to 8: Axis No. (number of control axes)