Specifications

II Parameters
Base Specifications Parameters
II - 86
【#1287(PR)】 ext23
bit1: Inclined surface coordinate display (for M system only)
0: Display the position which includes tool length offset.
1: Display the position on the program which excludes tool length offset.
bit2: Inclined surface coordinate display (for M system only)
0: Display the position which includes tool radius compensation.
1: Display the position on the program which excludes tool radius compensation.
bit4: Relative coordinate display
(M system)
0: Display the position which includes tool length offset.
1: Display the position on the program which excludes tool length offset.
(L system)
0: Display the position which includes tool shape compensation.
1: Display the position on the program which excludes tool shape compensation.
bit5: Relative coordinate display
(M system)
0: Display the position which includes tool radius compensation.
1: Display the position on the program which excludes tool radius compensation.
(L system)
0: Display the position which includes nose R compensation.
1: Display the position on the program which excludes nose R compensation.
bit6: Absolute coordinate display
Select how coordinate values are displayed when absolute coordinate display is selected
("#1221 aux05/bit0"="1").
(M system)
0: Display the position which includes tool length offset.
1: Display the position on the program which excludes tool length offset.
(L system)
0: Display the position which includes tool shape compensation.
1: Display the position on the program which excludes tool shape compensation.
bit7: Absolute coordinate display
Select how coordinate values are displayed when absolute coordinate display is selected
("#1221 aux05/bit0"="1").
(M system)
0: Display the position which includes tool radius compensation.
1: Display the position on the program which excludes tool radius compensation.
(L system)
0: Display the position which includes nose R compensation.
1: Display the position on the program which excludes nose R compensation.
【#1288(PR)】 ext24
bit0: MDI program clear
Select whether to clear the MDI programs when MDI operation ends, the power is turned
ON again, reset is input, or emergency stop is canceled.
0: Not clear.
1: Clear (save only % programs).
【#1289(PR)】 ext25
bit0: Tool radius compensation switch corner judgment method (Nose R comp.)
Select the criterion to execute the outer rounding at the small corner in tool radius
compensation.
(L system)
0: The corner angle is 0°; linear-linear; G02-G03/G03-G02; the radius is the same.
(Conventional method)
1: The corner angle is 1° or smaller; linear-linear; G02-G03/G03-G02; the radius is
almost the same. (Method for rounding minute corner angle)
(M system)
0: The corner angle is 1° or smaller; linear-linear; G02-G03/G03-G02. (Conventional
method)
1: The corner angle is 1° or smaller; linear-linear; G02-G03/G03-G02; the radius is
almost the same. (Method for rounding minute corner angle)
【#1290(PR)】 ext26
Not used. Set to "0".
【#1291(PR)】 ext27
Not used. Set to "0".
【#1292(PR)】 ext28
Not used. Set to "0".
【#1293(PR)】 ext29
Not used. Set to "0".
【#1294(PR)】 ext30
Not used. Set to "0".