Specifications

II Parameters
Base Specifications Parameters
II - 83
【#1280(PR)】 ext16
bit0: I/F per axis during mixed control (cross axis control)
Select how to handle the following PLC interface for axes interchanged with the mixed
control (cross axis control).
- Mirror image
- Manual/automatic interlock
- Manual/automatic machine lock
0: Follows axis configuration before the mixed control (cross axis control).
1: Follows axis configuration after the mixed control (cross axis control).
(Example)
The device No. of automatic interlock (+) for X1 will be as follows when the mixed control
(cross axis control) is executed with the 1st axis (X1) in the 1st part system and 1st axis
(X2) in the 2nd part system.
When "0" is set: Y820 (interface for 1st axis in 1st part system)
When "1" is set: Y828 (interface for 1st axis in 2nd part system)
(Note) If the number of axes in the part system changes with the mixed control (cross axis
control), the interface of the target axis may change when this parameter is set to "1".
(Example)
When 1st part system's C axis is moved to 2nd part system with a 1st part system (X, Z, C,
Y) and 2nd part system (X, Z) configuration:
When "1" is set: Y82A, Y7CA, Y8AA and later will be the interface for the C axis moved to
the 2nd part system. Y7C2, Y822, Y8A2 and later will be the interface of the Y axis in the 1st
part system, because the axes following the removed C axis (third place) are shifted up.
bit1: Mixed control (cross axis control) cancel with reset
Select whether to cancel the mixed control (cross axis control) when reset is applied.
0: Cancel.
1: Not cancel.
bit2: Interchange coordinate position display
Select whether to display interchanged (or moved) coordinate positions in the mixed control
(cross axis control).
This setting will be applied when the axes are moved, as well as when the axes are
interchanged.
0: Display interchanged (or moved) coordinate positions.
1: Display coordinate positions without being interchanged (nor moved).
(Example)
When 1st part system's C axis is moved to 2nd part system with a 1st part system (X, Z, C,
Y) and 2nd part system (X, Z) configuration:
1st part system: X, Z and Y coordinate positions are displayed.
2nd part system: X, Z and C coordinate positions are displayed.
bit3: Reset operation for synchronization/super-imposition control
Select whether to cancel synchronization/superimposition control when reset is applied.
0: Cancel.
1: Not cancel.
bit4: Mixed control (cross axis control) command method
Select how to command mixed control (cross axis control).
0: Use PLC interface signal for mixed control
1: Use G command for mixed control
bit5: Command method of control axis synchronization across part systems
Select how to command the control axis synchronization across part systems.
0: Use PLC I/F.
1: Use G command.
bit6: Interchange machine position display
Select whether to display interchanged (or moved) machine positions in the mixed control
(cross axis control).
This setting will be followed not only when the axes are interchanged but also when the
axes are moved.
(Note 1) This parameter is enabled when "#1280 ext16/bit2 (Interchange coordinate
position display)" is "0".
0: Display interchanged (or moved) machine positions.
1: Display machine positions without being interchanged (nor moved).
bit7: Control axis superimposition command method
Select how to command control axis superimposition.
0: Use G command for control axis superimposition.
1: Use PLC interface signal for control axis superimposition.