Specifications

I Alarms
Operation Errors (M)
I - 10
M01 Synchronization mismatch 1030
Details
Different M codes were each commanded as synchronization M code in each of the two part
systems.
Synchronization with the "!" code was commanded in another part system during M code syn-
chronization.
Synchronization with the M code was commanded in another part system during synchroniza-
tion with the "!" code.
Remedy
- Correct the program so that the M codes match.
- Correct the program so that the same synchronization codes are commanded.
M01 Multiple C axes select invalid 1031
Details
The "C axis selection" signal has been changed when the multiple C axes selection is not
available.
The selected axis by the "C axis selection" signal cannot be controlled for the multiple C axes
selection.
Remedy
- Correct the parameter settings and program.
M01 Tap retract Sp select illegal 1032
Details
Tap retract has been executed with a different spindle selected. Cutting feed is in wait state
until synchronization is completed.
Remedy
- Select the spindle for which tap cycle was halted before turning ON the "tap retract" signal.
M01 Sp-Sp polygon cut interlock 1033
Details
Cutting feed is in wait state until synchronization is completed.
Remedy
- Wait for the synchronization to end.
M01 Mixed sync ctrl prmtr illegal 1034
Details
There is a mistake in the settings of mixed control axis parameters (crsax [1] to [8]).
Mixed control was attempted within one and the same part system.
Any of the parameter settings is disabling mixed control.
Remedy
- Correct the parameter settings for the mixed control (cross axis control).
M01 Mixed sync ctrl disable modal 1035
Details
Mixed control (cross axis control) was commanded for a part system in which the mixed con-
trol (cross axis control) is disabled as shown below.
- During nose R compensation mode
- During pole coordinate interpolation mode
- During cylindrical interpolation mode
- During balance cut mode
- During fixed cycle machining mode
- During facing turret mirror image
- During constant surface speed control mode
- During hobbing mode
- During axis name switch
An axis was transferred to another part system, and mixed control was attempted with the part
system's maximum number of control axes exceeded.
An axis was removed from the part system, and mixed control was attempted with the part sys-
tem's number of axes zero.
Another axis exchange was attempted to the axis which was already transferred to another
part system for mixed control.
Mixed control was attempted with an axis of a part system not in automatic operation.
Remedy
- Correct the program.
M01 Synchro ctrl setting disable 1036
Details
"Synchronous control operation method" was set (with R2589) when the mode was not the C
axis mode.
"Synchronous control operation method" was set (with R2589) in the zero point not set state.
Mirror image is disabled.
External mirror image or parameter mirror image was commanded during facing turret mirror
image.
Remedy
- Set the contents of the R2589 register to "0".
- Correct the program and parameters.
M01 Synchro start/cancel disable 1037
Details
Synchronous control start/cancel command was issued when the start/cancel is disabled.
Remedy
- Correct the program and parameters.
M01 Move cmnd invld to synchro ax 1038
Details
A travel command was issued to a synchronous axis in synchronous control.
Remedy
- Correct the program.
M01 No spindle speed clamp 1043
Details
The constant surface speed command (G96) was issued to the spindle which is not selected
for the spindle speed clamp command (G92/G50) under Multiple spindle control II.
Remedy
Press the reset key and carry out the remedy below.
- Select the spindle before commanding G92/G50.