Specifications

II Parameters
Base Specifications Parameters
II - 78
【#1270(PR)】 ext06
bit3: Finished shape judgement disable
Select to enable/disable the judgement of shape when the finished shape's Z axis (or X axis
at G72 command) does not move monotonously. Program error (a shape change at pocket
machining) can be avoided when selected to disable.
0: Enable
1: Disable
bit4: Switch chamfering operation
Select the operation to be performed when the cycle start point is exceeded as a result of
chamfering in a thread cutting cycle.
0: Output a program error (P192).
1: Stop chamfering upon arrival at the cycle start point, and then move to the end point
of the thread cutting block at a rapid traverse rate.
bit5: Coordinate rotation angle without command (for L system only)
Select the operation when there is no rotation angle command R for the coordinate rotation.
0: Use the previously commanded value (modal value). If the command is the first
issued command, the rotation angle will be 0°.
1: Use the set value in "#8081 Gcode Rotat".
bit6: Switch continuous thread cutting Z phase wait operation
Select when to start the 2nd block thread cutting when there is a command with no
movement (MST command, etc.) between the thread cutting blocks.
0: Wait for the spindle's single rotation synchronization signal before starting the
movement.
1: Start movement without waiting for the spindle's single rotation synchronization
signal.
bit7: Handle C axis coordinate during cylindrical interpolation
Specify whether to keep the rotary axis coordinate as before the cylindrical interpolation
start command is issued during the cylindrical interpolation.
0: Not keep
1: Keep