Specifications

II Parameters
Base Specifications Parameters
II - 77
【#1255】 set27
Not used. Set to "0".
【#1256】 set28
Not used. Set to "0".
【#1257】 set29
Not used. Set to "0".
【#1258(PR)】 set30
bit0: Skip I/F switch
Select A or B contact for the skip interface.
0: A contact (Skip operation starts at rising edge of a signal)
1: B contact (Skip operation starts at falling edge of a signal)
(Note) This parameter is not applied to PLC skip.
【#1259】 set31
bit0 : Enable normal life tool's data count (for M system only)
Select whether to enable or disable too use data counting when the tool
status is 2 (normal life tool).
0: Not count the use data of normal life tool.
1: Count the use data of normal life tool.
【#1260】 set32
Not used. Set to "0".
【#1261】 set33
Not used. Set to "0".
【#1262】 set34
Not used. Set to "0".
【#1263】 set35
Not used. Set to "0".
【#1264】 set36
Not used. Set to "0".
【#1265(PR)】 ext01
bit0: Command format 1
Select the command format for the fixed cycle for compound lathe.
0: Conventional format
1: MITSUBISHI CNC special format (1 block command method)
bit1: Command format 2
Select the command format for the lathe fixed cycle.
0: Conventional format
1: MITSUBISHI CNC special format
bit2: Command format 3
Select the command format for the hole drilling fixed cycle.
0: Conventional format
1: MITSUBISHI CNC special format
【#1266(PR)】 ext02
Not used. Set to "0".
【#1267(PR)】 ext03
bit0: G code type
Select the high-speed high-accuracy G code type.
0: Conventional format (G61.1)
1: MITSUBISHI special format (G08P1)
【#1268(PR)】 ext04
bit2 : Enable synchronous tapping per minute
Select whether to enable feed per minute with the F command of synchronous tapping
cycle.
0: Disable (Command in pitch regardless of "G group 5" modal)
1: Enable (Follow "G group 5" modal)
【#1269(PR)】 ext05
Not used. Set to "0".