Specifications

II Parameters
Base Specifications Parameters
II - 74
【#1235】 set07
bit0: Helical interpolation speed 2
0: Select normal speed designation also for 3rd axis
1: Select arc plane element speed designation
bit2: Fixed type chopping compensation valid only at start
When the fixed type compensation value is selected, the method can be changed to the
compensation value sequential update type after the first four cycles.
0: Disable the method changeover
1: Enable the method changeover
bit4: Selection condition of synchronous tapping gear step
Select the parameters that determine the gear step for synchronous tapping.
0: #3005 through #3008 (smax1 to 4) when "#1223 aux07/bit7" is "0".
Or #3013 through #3016 (stap1 to 4) when "#1223 aux07/bit7" is "1".
1: Always #3013 through #3016 (stap1 to 4)
【#1236】 set08
bit0: Manual rotary axis feedrate unit
Select the unit of manual rotary axis feedrate.
0: Fixed to [°/min]
1: Same speed as before (When inch command, the speed is the command speed
divided by 25.4.)
bit1: Spindle speed detection
Select the pulse input source of actual spindle rotation speed (R6506/R6507) when the
spindle encoder serial connection is selected ("#3025 enc-on" is set to "2").
0: Serial input
1: Encoder input connector
bit2: Current limit droop cancel invalid
Select whether to cancel the position droop when the current limit changeover signal is
canceled.
0: Cancel the droop.
1: Not cancel the droop.
bit3: Rotary axis command speed scale
Select to multiply the rotary axis command speed by 10 times.
0: Invalid
1: During initial inching, the rotary axis command speed is multiplied by 10. In other
words, if "F100" is commanded, the speed will be the same as when 1000°/min is
commanded.
The rotary axis speed display unit will be 10°/min.
【#1237(PR)】 set09
Not used. Set to "0".
【#1238(PR)】 set10
bit0: Switch G36 function
Select the function, the automatic tool length measurement or arc thread cutting (CCW), to
be applied to G36 when the G code system 6 or 7 is selected.
0: Automatic tool length measurement
1: Arc thread cutting (CCW)
bit6: Switch absolute position detection alarm
Select the output destination of the absolute position detection alarm.
0: NC alarm 4 (AL4)
1: NC alarm 5 (AL5)
(Note) The absolute position detection alarm is listed in the alarm history regardless of this
parameter setting.
bit7: Switch operation alarm
Select whether to enable the NC alarm 5 (AL5) signal output.
0: Disable NC alarm 5 (AL5) (default)
All operation alarms will be output to NC alarm 4 (AL4).
All operation alarms will be recorded in the alarm history.
1: Enable NC alarm 5 (AL5)
The following operation alarms will be output to NC alarm 5 (AL5), not to NC alarm 4
(AL4).
The operation alarms output to NC alarm 5 (AL5) will not be recorded in the alarm
history.
- External interlock axis found (M01 0004)
- Cutting override zero (M01 0102)
- External feedrate zero (M01 0103)
- Block start interlock (M01 0109)
- Cutting block start interlock (M01 0110)
- Cutting interlock for spindle-spindle polygon (G51.2) (M01 1033)