Specifications

I Alarms
Operation Errors (M)
I - 9
M01 Superimposition command illegal 1004
Details
- Superimposition start command was issued to the axis which is executing the following func-
tions.
Synchronization control
Milling interpolation
- Superimposition start command was issued to the axis which was under superimposition
control.
- The superimposition command was issued to an axis that belongs to the same part system
as a basic or synchronous axis of synchronization across part systems.
Remedy
- Correct the program.
M01 G114.n command illegal 1005
Details
G114.n has been commanded during the execution of G114.n.
G51.2 has been commanded when G51.2 spindle-spindle polygon machining mode has been
already entered at another part system.
Remedy
- Command G113 to cancel the operation.
- Turn ON the "spindle synchronization cancel" signal to cancel the operation.
- Command G50.2 to cancel the operation.
- Turn ON the "spindle-spindle polygon cancel" signal to cancel the operation.
M01 Spindle in-use by synchro tap 1007
Details
The spindle is being used in synchronized tapping.
Remedy
- Cancel the synchronized tapping.
M01 GB spindle synchro signal OFF 1014
Details
- A forward run, reverse run, orientation, synchronous tapping, spindle synchronization, tool
spindle synchronization I, tool spindle synchronization II or C-axis servo ON command was
issued to the reference spindle while the guide bushing spindle synchronization signal was
OFF.
- The guide bushing spindle synchronization signal was turned OFF during a forward run, re-
verse run, orientation, synchronous tapping, spindle synchronization, tool spindle synchro-
nization I, tool spindle synchronization II or C-axis servo ON command.
Remedy
- Check the ladder program.
Details
- Orientation was commanded during the “guide bushing spindle synchronization” signal ON
with spindle zero point detection with contactless switch and turret indexing enabled.
- C axis servo ON was commanded during the “guide bushing spindle synchronization” signal
ON with spindle C axis parameter change enabled.
Remedy
- Check the parameters.
M01 GB SP sync:Spindle type error 1015
Details
- A spindle drive unit other than the drive unit after MDS-D series or analog spindle is used
for the master spindle or guide bushing spindle.
Remedy
- Check the parameters.
- Change the reference spindle or guide bushing spindle to a spindle that is drive unit after
MDS-D series.
M01 GB SP sync:Phase mem sgnl ilgl 1021
Details
- The guide bushing spindle synchronization phase memory signal was turned ON while the
master spindle or guide bushing spindle was rotating.
- The guide bushing spindle synchronization phase memory signal was turned ON while the
guide bushing spindle synchronization signal was OFF.
Remedy
- Check the ladder program.
M01 GB SP sync:Phase set sgnl ilgl 1022
Details
- The guide bushing spindle synchronization phase alignment signal was turned ON while the
master spindle or guide bushing spindle was stopped.
Remedy
- Check the ladder program.
M01 GB SP sync:Z phase not pass 1023
Details
- When the guide bushing spindle synchronization phase memory signal was ON, the master
spindle or guide bushing spindle’s Z-phase was not passed.
Remedy
- Check the ladder program.
M01 SP-C ax ctrl runs independntly 1026
Details
C axis mode command has been issued for polygon machining spindle.
C axis mode command has been issued for synchronized tapping spindle.
Polygon command has been issued for synchronized tapping spindle.
Spindle is being used as spindle/C axis.
Remedy
- Cancel the C axis command.
- Cancel the polygon machining command.
- Cancel the C axis with servo OFF.