Specifications

II Parameters
Base Specifications Parameters
II - 70
【#1224】 aux08
bit0: Sampling data output
Select whether to enable the sampling data output.
0: Disable
1: Enable
【#1225】 aux09
bit7: Enable/disable spindle rotation speed clamp
Select whether to enable the spindle rotation speed clamp by the G92 S or Q command for
the spindle command rotation speed (R7000) set with the user ladder.
0: Enable
1: Disable
【#1226】 aux10
bit0: Tool compensation data for external workpiece coordinate offset measurement
Select the tool compensation data to be used for external workpiece coordinate offset
measurement.
0: Tool length data and tool nose wear data
1: Tool length data
bit1: Optional block skip type
Select whether to enable the optional block skip in the middle of a block.
0: Enable only at the beginning of a block.
1: Enable in the middle of a block, as well as at the beginning of the block.
bit2: Single block stop timing
Select the timing at which the single block signal is activated.
0: When the signal goes ON while automatic operation is starting, the block will stop
after finished.
1: When the signal is ON at the end of the block, the block will stop.
bit3: C-axis reference position return type
Select the C-axis reference position return type.
0: Basic position return is performed by the G28 reference position return command or
by activating the manual reference position return. The basic point dog is used.
1: When the first C-axis command is issued after the C-axis mode is entered in
automatic mode, reference position return is performed before the execution of the
block. The reference position return is also performed by the G28 reference position
return command or by activating the manual reference position return. The Z phase
of the encoder is used.
bit4: S command during constant surface speed
Select whether to output a strobe signal when the S command is issued in constant surface
speed mode.
0: Not output any strobe signal in constant surface speed mode.
1: Output strobe signals in constant surface speed mode.
bit5: Arbitrary allocation of dog signal
Select whether to enable the arbitrary allocation parameter for the origin dog and H/W OT.
0: Disable (Fixed device is used.)
1: Enable (Device is specified by the parameter.)