Specifications

II Parameters
Base Specifications Parameters
II - 69
【#1221】 aux05
bit0: Workpiece coordinate/ Absolute coordinate display switching
Select the coordinate to display when workpiece coordinate position counter is selected for
the Monitor screen counter display.
0: Workpiece coordinate
1: Absolute coordinate
【#1222】 aux06
bit4: Minimum cut-in amount selection
Select the minimum cut-in amount command value for the compound thread cutting cycle
(G76 command).
0: The minimum cut-in amount (Q) will be "0".
1: The minimum cut-in amount (Q) will be set in the the last command value (it is
retained even after the NC power has been turned off).
bit5: Fixed cycle for compound lathe command format check selection
Select the operation when the 1st block of the fixed cycle for compound lathe is omitted
while the conventional format is selected ("#1265 ext01/bit0" is set to "0").
0: Program error (P33) will occur.
1: Parameter setting value will be used.
bit7: Reference position return deceleration check method
Select the deceleration check method to be used during automatic reference position
return.
0: In-position check
1: Commanded deceleration check
【#1223】 aux07
bit1: Deceleration check method 2
Select the deceleration check method in G1+G9.
0: Command deceleration check in G1+G9
1: In-position check in G1+G9
The deceleration check is not performed for the commands except G1+G9.
When "#1306 InpsTyp deceleration check specification type" is set to "1" (Deceleration
check specification type 2), this parameter will be invalid.
bit2: Synchronous tap R-point in-position check
Select whether to enable the synchronous tap I-point -> R-point in-position check.
0: Disable
1: Enable
(Note) This parameter is valid only when "1" (Enable in-position check) is set for "#1223
aux07/bit3 Synchronous tap in-position check improvement".
bit3: Synchronous tap in-position check improvement
Select whether to enable the synchronous tap in-position check improvement.
0: Disable
1: Enable
Related parameters:
#1223/bit2 Synchronous tap R-point in-position check
#1223/bit4 Synchronous tap hole bottom in-position check
#1223/bit5 Synchronous tap R-point in-position check 2
bit4: Synchronous tap hole bottom in-position check
Select whether to enable the synchronous tap hole bottom in-position check.
0: Disable
1: Enable
(Note) This parameter is valid only when "1" (Enable in-position check) is set for "#1223
aux07/bit3 Synchronous tap in-position check improvement".
bit5: Synchronous tap R-point in-position check 2
Select whether to enable the synchronous tap R-point in-position check.
0: Disable
1: Enable
(Note) This parameter is valid only when "1" (Enable in-position check) is set for "#1223
aux07/bit3 Synchronous tap in-position check improvement".
bit6: Cancel synchronous tap (, S) return
0: Retain the spindle speed (, S) in synchronous tap return
1: Cancel the spindle speed (, S) in synchronous tap return with G80
bit7: Synchronous tap method
Select the synchronous tapping method.
0: Synchronous tapping with multi-step acceleration and rapid return
1: Conventional type synchronous tapping