Specifications

II Parameters
Base Specifications Parameters
II - 64
【#1200(PR)】 G0_acc Validate acceleration and deceleration with inclination constant G0
Select the acceleration and deceleration type when a rapid traverse command is issued.
0: Acceleration and deceleration with constant time (conventional type)
1: Acceleration and deceleration with a constant angle of inclination
(Note) When rapid traverse constant inclination multi-step acceleration/deceleration is
valid, this parameter will be invalid.
【#1201(PR)】 G1_acc Validate acceleration and deceleration with inclination constant G1
Select the acceleration and deceleration type when a linear interpolation command is
issued.
0: Acceleration and deceleration with constant time (conventional type)
1: Acceleration and deceleration with a constant angle of inclination
【#1202】 mirofs Distance between facing turrets (for L system only)
Set the distance between tools (edges) (between facing turrets).
---Setting range---
0 to 99999.999 (mm)
【#1203】 TmirS1 Select turrets as facing turrets with T command (for L system only)
Select the turrets, which correspond to the tool Nos. 1 to 32, as facing turrets for T code
mirror image.
---Setting range---
0 to FFFFFFFF
【#1204】 TmirS2 Select turrets as facing turrets with T command (for L system only)
Select the turrets, which correspond to the tool Nos. 33 to 64, as facing turrets for T code
mirror image.
---Setting range---
0 to FFFFFFFF
【#1205】 G0bdcc Acceleration and deceleration before G0 interpolation
0: Post-interpolation acceleration/deceleration is applied to G00.
1: Pre-interpolation acceleration/deceleration is applied to G00 even in the high
accuracy control mode.
2: Rapid traverse constant inclination multi-step acceleration/deceleration is enabled.
(Note) Set "0" for the 2nd part system and the following.
When the option of high-accuracy control option in 2 part systems is enabled, "1" can
be set for the 2nd part system.
【#1206】 G1bF Maximum speed
Set a cutting feedrate when applying pre-interpolation acceleration/deceleration.
When high-accuracy control time constant expansion is valid, set the maximum of cutting
feed clamp speed of each axis.
---Setting range---
1 to 999999 (mm/min)
【#1207】 G1btL Time constant
Set a cutting feed time constant when applying pre-interpolation acceleration/deceleration.
When set to "0", the time constant will be clamped at 1ms.
---Setting range---
Without high-accuracy control time constant expansion: 0 to 5000 (ms)
With high-accuracy control time constant expansion: 0 to 30000 (ms)
Cutting feed Acc Cutting feed acceleration
Displays cutting feed acceleration.
【#1208】 RCK Arc radius error compensation factor
Set a coefficient for arc radius error compensation.
An arc radius error compensation amount can be increased or decreased between -60.0
and +20.0%.
---Setting range---
-60.0 to +20.0 (%)
【#1209】 cirdcc Arc deceleration speed
Set the deceleration speed at the arc entrance or exit.
---Setting range---
1 to 999999 (mm/min)
G1btL
G1bF
Time
Speed