Specifications

II Parameters
Base Specifications Parameters
II - 60
【#1141】 Mn200 M code number
Set the first number of M code that corresponds to the setup Nos. from 200 to 299.
---Setting range---
0 to 99999999
【#1142】 Mn300 M code number
Set the first number of M code that corresponds to the setup Nos. from 300 to 399.
---Setting range---
0 to 99999999
【#1143】 Mn400 M code number
Set the first number of M code that corresponds to the setup Nos. from 400 to 499.
---Setting range---
0 to 99999999
【#1144】 mdlkof MDI setup lock
Select whether to enable MDI setting in non-MDI mode.
0: Disable MDI setting
1: Enable MDI setting
【#1145】 I_abs Manual ABS parameter
Select how to handle the absolute position data during automatic handle interrupt.
0: Absolute position data will be renewed if manual ABS switch is ON. If it is OFF, data
won't be renewed.
1: Follow the "intabs" state when "#1061 intabs" is enabled
【#1146】 Sclamp Spindle rotation speed clamp function
Select how to handle the spindle rotation speed clamp function with the G92S command.
0: G92S command is handled as a clamp command only in the G96 state (during
constant surface speed control).
G92S will be handled as normal S command in G97 state (constant surface speed
OFF).
1: The S command in the same block as G92 is constantly handled as a clamp
command
【#1147】 smin_V Minimum spindle rotation speed clamp type
Specify the type of spindle min. rotation speed clamp value.
0: Rotation speed setting
1: Output voltage coefficient setting
Set “#3023 smini” according to this type setting.
【#1148】 I_G611 Initial high precision
Set the high accuracy control mode for the modal state when the power is turned ON.
0: G64 (cutting mode) at power ON
1: G61.1 (high-accuracy control mode) at power ON
(Note) When the option of high-accuracy control in 2 part systems is enabled, it will be
enabled in both systems.
【#1149】 cireft Arc deceleration speed change
Select whether to decelerate at the arc entrance or exit.
0: Not decelerate
1: Decelerate
【#1151】 rstint Reset initial
Select whether to initialize (power ON state) the modals by resetting.
0: Not initialize modal state
1: Initialize modal state
【#1153】 FixbDc Hole bottom deceleration check
Select whether to perform a deceleration check or in-position check at the hole bottom in a
hole drilling cycle. This parameter is enabled only for a hole drilling cycle in which no dwell
command can be issued at the hole bottom.
0: Perform no deceleration check and in-position check
1: Perform deceleration check
2: Perform in-position check
【#1154(PR)】 pdoor
Not used. Set to "0".
【#1155】 DOOR_m
Not used. Set to "100".
---Setting range---
100
【#1156】 DOOR_s
Not used. Set to "100".
---Setting range---
100
【#1157】 F0atrn
Not used. Set to "0".