Specifications

II Parameters
Base Specifications Parameters
II - 54
【#1044(PR)】 auxno MR-J2-CT Connections
Set the number of MR-J2-CTs connected.
(Note) The number of MR-J2-CTs possible to connect and setting range are different
according to the model.
Check the specifications of each series.
【#1050(PR)】 MemPrg
Not used. Set to "0".
【#1051(PR)】 MemTol Tool compensation memory common for part systems
0: Tool compensation memory separate for part systems
1: Tool compensation memory common for part systems
【#1052(PR)】 MemVal No. of common variables shared in part system designation
0: Common variables common for part systems (number fixed)
#100 - : Per part system
#500 - : Common for part systems
1: Common variables common for part systems (number designation)
#100 - : Designate with V1comN
#500 - : Designate with V0comN
(Note) When this parameter is changed, the file system will be changed after the power is
turned ON.
So always execute format.
The new format will be enabled after turning the power ON again.
Setting order
(1) MemVal changeover -> (2) Turn power ON again -> (3) Format -> (4) Turn power ON
again
【#1061(PR)】 intabs Manual ABS updating
Select whether to update the absolute position data during automatic handle interrupt.
This parameter is enabled only when "#1145 l_abs" is set to “1”.
0: Do not update (coordinate system shifted the amount of the interruption)
1: Update (same coordinates as when interrupt did not occur will be applied)
【#1062】 T_cmp Tool compensation function
Select whether the tool length compensation and wear compensation are enabled during T
command execution.
0 : Tool length compensation enable Wear compensation enable
1 : Tool length compensation enable Wear compensation disable
2 : Tool length compensation disable Wear compensation enable
3 : Tool length compensation disable Wear compensation disable
【#1063】 mandog Manual dog-type
Select the manual reference position return method for the second return (after the
coordinate system is established) and later.
The initial reference position return after the power ON is performed with dog-type return,
and the coordinate system will be established.
(This setting is not required when the absolute position detection is used.)
0: High speed return
1: Dog-type
【#1064(PR)】 svof Error correction
Select whether to correct the error when the servo is OFF.
0: Not correct the error
The command value will not change during servo OFF, and the movement amount
during servo OFF will be handled as droop. When the servo is turned ON the next
time, the axis will move to the command position where it used to be when the servo
was turned OFF.
1: Correct the error
The command value and the current position will follow the feedback position. When
the servo is turned ON the next time, the axis will not move.
During servo READY OFF, the operation will be always the same as of "Correct the error".
(The current position will follow the position of the axis.)
【#1068(PR)】 slavno Secondary axis number
Set the axis number of the secondary axis in synchronous control.
The axis number is an NC number excluding the spindle and PLC axis.
Two or more secondary axes cannot be set for one primary axis.
This parameter cannot be set for a secondary axis.
When using the multi-part system, the relation of the primary axis and secondary axis
cannot extend over part systems.
0: No secondary axis
1 to 16: First to sixteenth axis
【#1069】 no_dsp Axis with no counter display
Select whether to display the axis counter or not.
This setting is enabled on the counter display screen (relative position counter, etc.).
0: Display
1: Not display
【#1070】 axoff Axis removal
Select whether to enable or disable axis removal control.
0: Disable
1: Enable