Specifications

II Parameters
Base Specifications Parameters
II - 50
2. Base Specifications Parameters
The parameters with "(PR)" requires the CNC to be turned OFF after the settings. Turn the power OFF and
ON to enable the parameter settings.
(Note) This parameter description is common for M700V/M70V/E70 Series.
It is written on the assumption that all option functions are added.
Confirm with the specifications issued by the machine tool builder before starting use.
【#1001(PR)】 SYS_ON System validation setup
Select the existence of PLC axes and part systems.
0: Not exist
1: Exist
【#1002(PR)】 axisno Number of axes
Set the number of control axes and PLC axes.
A total of 16 axes can be set.
Control axis: 0 to 8
PLC axis: 0 to 6
When set to "0", the number of control axes in the part system will be "0". Do not set the
number of control axes of the first part system to "0".
(Note) The setting range differs according to the model.
【#1003(PR)】 iunit Input setup unit
Select the input setting value for each part system and the PLC axis.
Increments in parameters will follow this selection.
B : 1 μm
C : 0.1 μm
D : 0.01 μm (10nm)
E : 0.001 μm (1nm)
【#1004(PR)】 ctrl_unit Control unit
Select the control increment for each part system and PLC axis.
Select the increment for the NC internal position data, communication data between the NC
and drive unit, and the servo travel data. Although the standard value is "D", set the
optimum value according to the series and specification.
B : 1 μm
C : 0.1 μm
D : 0.01 μm (10nm)
E : 0.001 μm (1nm)
【#1005(PR)】 plcunit PLC unit
Select the PLC interface setting and display increment.
The PLC interface setting and display increment will follow this specification. Note that the
PLC axis will follow “#1003 iunit”.
B : 1 μm
C : 0.1 μm
D : 0.01 μm (10nm)
E : 0.001 μm (1nm)
【#1006(PR)】 mcmpunit Machine error compensation unit
Select the machine error compensation setting and display increment.
The parameters related to machine error compensation (backlash, pitch error
compensation, etc.) and PLC interface (external machine coordinate system compensation)
will follow this selection.
B : 1 μm
C : 0.1 μm
D : 0.01 μm (10nm)
E : 0.001 μm (1nm)
【#1007(PR)】 System type select System type select
Select the NC system type.
0: Machining center system (M system)
1: Lathe system (L system)
(Note 1) If the setting value is out of range, M system will be selected.
(Note 2) This parameter is valid only for M700VS/M70V/M70/E70 Series. (M700/M700VW
series doesn't support this parameter.)
【#1010(PR)】 srvunit Output unit (servo)
Select the output increment to servo. Although the standard value is "D", set the optimum
value according to the series and specification.
B : 1 μm
C : 0.1 μm
D : 0.01 μm (10nm)
E : 0.001 μm (1nm)