Specifications

II Parameters
User Parameters
II - 49
【#19008】 PRM coord rot type
Select the start point of the initial travel command after parameter coordinate rotation.
0: Calculate the end position, assuming that the start point rotates in accordance with
the coordinates rotation.
1: Calculate the end position using the current position on the local coordinate system
before rotating, without rotating the start point in accordance with the coordinates
rotation.
【#19401】 G33.n chamfer spd
Not used.
【#19405】 Rotary ax drawing
Specify this parameter to draw a path of C axis (rotary axis) according to its rotation in the
graphic trace and 2D graphic trace.
When "#1013 axname" is set to "C", the axis is handled as a rotary axis.
By setting this parameter to "C", a rotation path around the Z axis on actual workpiece can
be expressed.
When the Graphic check rotary axis drawing option or Graphic trace rotary axis drawing
option is disabled, this parameter is ignored.
C：Enable this function
0：Disable this function
（Setting is cleared when "0" is set）
【#19406】 Hob retract ON at alarm
Select whether to enable the retract at an alarm during hobbing.
0：Disable
1：Enable
【#19407】 Hob retract acceleration deceleration OFF
Select whether to disable the acceleration/deceleration of a retract.
0：Enable
1：Disable
【#19417】 Hole dec check 2
This is enabled when #1253 set25 bit2 is 1.
The operation at the hole bottom and the hole drilling stop position is as below.
0: Perform no deceleration check.
1: Perform command deceleration check.
2: Perform in-position check.
<Target fixed cycles>
Machining center: G81, G82, G83, G73
Lathe : G83, G87, G83.2
【#19425】 ManualB Std R1
Set a radius used as standard for the rotary axis speed.
When the setting value of #19425 is larger than that of "#19427 ManualB Std R2", #19425
setting will be used as surface speed control standard radius 2: #19427 setting will be used
as surface speed control standard radius 1.
---Setting range---
0 to 99999.999 (mm)
【#19426】 ManualB Std F1
This sets the rotary axis speed for surface speed control standard radius 1 (ManualB Std
R1).
When the setting value of #19426 is larger than that of "#19428 ManualB Std F2", #19426
setting will be used as surface speed control standard speed 2: #19427 setting will be used
as surface speed control standard speed 1.
---Setting range---
1 to 1000000 (°/min)
【#19427】 ManualB Std R2
Set a radius used as standard for the rotary axis speed.
When the same value is set as "#19425 ManualB Std R1", the surface speed control
standard speed 1 (ManualB Std F1) will be selected as the rotary axis speed if the radius is
less than that value. The surface speed control standard speed 2 (ManualB Std F2) is
selected if larger than the set value.
---Setting range---
0 to 99999.999 (mm)
【#19428】 ManualB Std F2
Set the rotary axis speed for surface speed control standard radius 2 (ManualB Std R2).
---Setting range---
1 to 1000000 (°/min)