Specifications

II Parameters
User Parameters
II - 48
【#10807】 Password
Set the password for sharing of machining data.
---Setting range---
4 characters (one-byte alphanumeric characters, without space)
【#10808】 Customer number
Set the user No. for sharing of machining data.
---Setting range---
Within 8 characters (one-byte alphanumeric characters, without space)
【#10812】 Anshin-net valid
Select whether to enable the Anshin-net function.
0: Disable
1: Enable
【#10813】 MTBnet enable
Select whether to enable the machine tool builder network system.
0: Disable
1: Enable
Standard setting: 0
(Note) Values other than "0" and "1" are invalid.
【#10814】 OP-notice condition
Select the condition of an NC for delivering an operator notification.
0: When the "automatic operation is starting" signal turns off. (Notifies the alarm if an
alarm occurs, and if not, notifies the completion of machining.)
1: If the designated "#10971 Complete condition" changes into "#10972 Complete CND
num", or the "automatic operation is starting" signal turns off due to an
alarm.(Notifies the alarm if an alarm occurs at the change of device condition, and if
not, notifies the completion of machining.)
2: When the "automatic operation is starting" signal turns off due to an alarm.
【#10815】 OP-notice mode
Select whether to cancel the mode after delivering an operator notification.
0: Cancel
1: Not cancel. Cancel the mode by screen operation.
【#19001】 Syn.tap(,S)cancel
0: Retain the spindle speed (,S) in synchronous tap return
1: Cancel the spindle speed (,S) in synchronous tap return with G80
The same value as "#1223 aux07/bit6" will be reflected. When either setting changes, the
other will change accordingly.
【#19002】 Zero-point mark
Select the position for displaying the zero point mark in the graphic trace and 2D check.
0: Machine coordinates zero point (same as conventional method)
1: Workpiece coordinate zero point
The same value as "#1231 set03/bit4" will be reflected. When either setting changes, the
other will change accordingly.
【#19003】 PRG coord rot type
Select the start point of the initial travel command after program coordinate rotation
command.
0: Calculate the end position using the current position on the local coordinate system
before rotating, without rotating the start point in accordance with the coordinates
rotation.
1: Calculate the end position, assuming that the start point rotates in accordance with
the coordinates rotation.
【#19004】 Tap feedrate limit
Set the upper limit of the cutting feed rate in synchronous tapping.
---Setting range---
0 to 1000(mm/rev)
(Note)Setting "0" disables this parameter.
When the commanded cutting feed rate in synchronous tapping exceeds this setting,
a program error (P184) will occur.
【#19005】 manual Fcmd2 clamp
Set a clamp speed coefficient (%) for manual speed command 2.
The feed rate is clamped at the command feed rate or rapid traverse rate for automatic
operation, which was multiplied by this parameter's value.
(Note)This setting is valid only for manual speed command 2.
---Setting range---
0 to 1000 (%)
0: 100% (Default value)
【#19006(PR)】 EOR Disable
Set whether to handle an EOR(%) in machining program as the end of program in automatic
operation, graphic check, program transfer to NC memory, program editing, and buffer
correction. Tape operation, Computer Link B, and serial input/output are not included.
0: An EOR(%) is handled as the end of machining program.
1: An EOR(%) is not handled as the end of machining program. The program will be
read to the end of file.