Specifications

II Parameters
User Parameters
II - 21
【#8927】 SP on 3rd part sys
Set a spindle No. to be displayed on the 3rd part system window when 2-part system
simultaneous display is valid. On the 15-type display, 1-part system display can be also
specified.
High-order: Select an upper side spindle No.
Low-order: Select a lower side spindle No.
(Note 1) When "00" is set in 2-part system simultaneous display, spindles will be displayed
in a default order (the 1st spindle on the upper side, the 2nd spindle on the lower
side). When "00" is set in 1-part system display of the 15-type display, all spindles will
be displayed.
(Note 2) If you designate a bigger number than the setting of "#1039 spinno", or either the
high-order or low-order setting is "0", the 1st spindle will be displayed.
(Note 3) If the low-order is set to "F", the spindle speed command value and the actual
rotation number which are specified in the high-order will be displayed.
---Setting range---
High-order: 0 to 6
Low-order: 0 to 6, F
【#8928】 SP on 4th part sys
Set a spindle No. to be displayed on the 4th part system window when 2-part system
simultaneous display is valid. On the 15-type display, 1-part system display can be also
specified.
High-order: Select an upper side spindle No.
Low-order: Select a lower side spindle No.
(Note 1) When "00" is set in 2-part system simultaneous display, spindles will be displayed
in a default order (the 1st spindle on the upper side, the 2nd spindle on the lower
side). When "00" is set in 1-part system display of the 15-type display, all spindles will
be displayed.
(Note 2) If you designate a bigger number than the setting of "#1039 spinno", or either the
high-order or low-order setting is "0", the 1st spindle will be displayed.
(Note 3) If the low-order is set to "F", the spindle speed command value and the actual
rotation number which are specified in the high-order will be displayed.
---Setting range---
High-order: 0 to 6
Low-order: 0 to 6, F
【#8929】 Disable=INPUT:comp
Select whether to enable [=INPUT] menu in [T-ofs] (tool compensation amount setting) or
[Coord] (workpiece coordinate system offset setting) menu on [Setup] screen.
0: Enable
1: Disable
【#8930】 Disable=INPUT:var
Select whether to enable [=INPUT] menu in [Com var] (common variables) menu on
[Monitr] screen.
0: Enable
1: Disable
【#8931】 Display/Set limit
Select the restriction of the connected NC's screen display/settings on/from the remote
control tool.
0: Permit the screen display/settings
1: Permit the screen display only
2: Restrict the connection
【#8932(PR)】 Hide measure scrn
Select whether to display the tool measurement screen and workpiece measurement
screen.
0: Display
1: Not display
【#8933】 Disable lngth comp
Set whether to disable the setting of tool shape compensation amount.
0: Not disable
1: Disable
The shape compensation amount covers the following data according to the tool
compensation type.
- Compensation type I ("1" in "#1037 cmdtyp(command type)")
... Compensation amount (the sum of shape compensation and wear compensation
amount)
- Compensation type II ("2" in "#1037 cmdtyp(command type)")
... Length dimension and radius dimension
- Compensation type III ("3" in "#1037 cmdtyp(command type)")
... Tool length and tool nose R