Specifications

II Parameters
User Parameters
II - 15
【#8707】 Skip past amout (H)
Set the difference (horizontal axis direction) between the skip read value and actual skip
position.
---Setting range---
-99999.999 to 99999.999 (mm)
【#8708】 Skip past amout (V)
Set the difference (vertical axis direction) between the skip read value and actual skip
position.
---Setting range---
-99999.999 to 99999.999 (mm)
【#8709】 EXT work sign rvs
Reverse the sign of external workpiece coordinate.
Select when using the external workpiece coordinate system with Z shift.
0: External workpiece offset without sign reversal
1: External workpiece offset with sign reversal
【#8710】 EXT work ofs invld
Set whether to enable external workpiece offset subtraction when setting the workpiece
coordinate offset.
0: Not subtract the external workpiece offset. (Conventional specification)
1: Subtract the external workpiece offset.
【#8711】 TLM L meas axis
Set the tool length measurement axis.
Set the "#1022 axname2" axis name.
---Setting range---
Axis name
(Note) If the axis name is illegal or not set, the 3rd axis name will be set as default.
【#8712】 TLM D meas axis
Set the tool diameter measurement axis.
Set the "#1022 axname2" axis name.
---Setting range---
Axis name
(Note) If the axis name is illegal or not set, the 1st axis name will be set as default.
【#8713】 Skip coord. Switch (For M system only)
Select the coordinate system for reading skip coordinate value.
Select whether to read the skip coordinate in the workpiece coordinate system or in the
feature coordinate system during inclined surface machining command.
Select whether to read the skip coordinate in the workpiece coordinate system or in the
workpiece installation coordinate system during workpiece installation error compensation.
0: Workpiece coordinate system
1: Feature coordinate system/Workpiece installation coordinate system
【#8880】 Subpro stor D0: dev
Select the storage destination (device) for the subprogram.
M:Memory, G:HD(Note), F:FD(Note), R:Memory card, D:Data server(Note)
(Note) This is available only with M700/M700VW Series.
When D0 is designated at a subprogram call, the subprogram to be called will be searched
from the device selected with this parameter.
(Example) M98 P (program No.), D0
-> Device: "#8880 Subpro stor D0: dev" device
Directory: "#8881 Subpro stor D0: dir" directory
The device and directory above will be searched.
(Note 1) When the called subprogram is not found in the selected storage destination, a
program error will occur.
(Note 2) When D0 to D4 is not designated at a subprogram call, the subprogram will be
searched from the memory.
【#8881】 Subpro stor D0: dir
Select the storage destination (directory) for the subprogram.
When D0 is designated at a subprogram call, the subprogram to be called will be searched
from the directory selected with this parameter.
Refer to "#8880 Subpro stor D0: dev".
---Setting range---
Directory 48 characters