Specifications

36
ADJUSTMENTS & SETTINGS (MAIN MENU)
MEMORY POSITION
LINE OFF/ON
H-POSI 0
V-POSI 0
H-POSI
V-POSI
+
+
LINE
MEMORY POSITION Memory and Position setting
• The print area settings made with this menu can be memorized as a user program
setting.
LINE Selects whether showing a frame of print area or not.
OFF A frame of print area is not shown.
ON A frame of print area is shown.
• When LINE is set to ON, the monitor colour may be changed, or the image may become
unstable horizontally depending on the H-POSI setting. In this case, set LINE to OFF.
• When the frame becomes over the setting area, the frame colour turns black.
• The frame is not displayed on the memory image.
H-POSI Changes the horizontal start position of input signal
The whole data image can be moved horizontally by changing the setting
number.
Setting area -8 ~ +8
• When setting minus value too large, the right side of the memory image is clipped on
the monitor. However, it is printed normally.
V-POSI Changes the vertical start position of input signal
The whole data image can be moved vertically by changing the setting
number.
Setting area -10 ~ 0
Repeat steps to to complete a comment.
• Skip if you do not change the cursor position.
• Only one comment can be stored regardless of the program number you chose in
SAVE PRG. Same comment will be stored in PRG. 1 through PRG.3. Different
comments cannot be stored in each program.
• When printing in FIELD mode, the comment is a little lower in quality.