Instruction manual

35
CONNECTIONS
PRINTING
ADJUSTMENTS
PRECAUTIONS FEATURES
PREPARATION
OTHERS
TROUBLE-
SHOOTING
BEFORE CALLING FOR SERVICE
Use the following troubleshooting chart to try to resolve any apparent defect in operation. If you are unable to resolve the
problem, unplug the power cord and contact your dealer.
Symptom Check and Remedy
No power Is the power cord plug disconnected from the outlet?
(when POWER lamp does not illuminate) →Connect the power cord plug to the outlet firmly.
After turning the power off, wait for approx. 2 minutes. Then turn on the
power.
No image appears on the monitor. Is the monitor and this unit connected correctly?
→Connect the monitor and this unit correctly.
Are the S-video signal or CAMERA IN signal inputted to this unit?
→Check the connection. Refer to pages 10.
Is the image stored in memory displayed on the monitor screen?
→Press MONITOR button to display the source image (LIVE).
The image is not stored in memory. Are the images being printed with full memorized memory page?
→Press the CLEAR button on the remote control unit after printing.
Then, store the image in the memory again.
Is the memory full in the status of “INCREMENT : OFF” or “CLEAR : OFF”?
→Store the image in the memory after pressing the CLEAR button on the
remote control unit.
(According to the setting conditions, the image can be stored in the
memory by setting INCREMENT to “PAGE”, CLEAR to “AFTER PRN” or
pressing the PRINT button.)
Is the memory full in the status of “MEM & STOP : ON”?
→Press CLEAR button on the remote control unit, and store the image again.
The image is not printed. Is the image stored in memory?
→Confirm that the image is stored in memory.
Is the print paper or ink sheet used up?
→Check the status.
Is the printing unit set correctly?
→Set the printing unit correctly.
The stored image in the memory cannot be Is the S size ink sheet installed when selecting “S” in “MODE : AUTO/S”? Or
enlarged to fill the maximum print area. is the L size ink sheet installed when selecting “AUTO” in “MODE : AUTO/S”?
→Check the current setting. Refer to page 15.
The color of picture quality is different Is the color of the image stored in the memory adjusted?
between the memorized image and the → Adjust the color of the image stored in the memory with the image
printed image. adjustment display (COLOR ADJ). Refer to page 30.
The color or picture quality is different between Is the image on the monitor screen adjusted?
the image on the monitor screen and the → Adjust the image on the monitor screen with “MONI R-SUB” and “MONI B-
printed image. (When the color and picture SUB” in the OUTPUT menu.
quality are same between the image stored in Refer to page 31.
the memory and the printed image.)