Instruction manual

32
ADJUSTMENTS & SETTINGS (SERVICE MENU)
MEM&STOP (Memory and Stop)
OFF The next image is overlaid in the memory.
PAGE Automatic increment stops when all pages become full. To overlay
a new image, print or clear the memorized image.
MEM&MONI (Memory and Monitor)
Switches the monitor display between the source image and
memory image after memorizing.
OFF Displays the source image.
ON Displays the memory image. (Initial setting)
• When KEEP MONI is set to OFF, the source image will be
displayed when starting printing.
KEEP MONI Selects the image displayed on the monitor during printing
OFF Displays the source image after starting printing.
ON Displays the source image after starting printing, when indicating it
before printing. Displays the memory image after starting printing,
when indicating it before printing.
AUTO CLEAR
OFF The printed memory image is not cleared.
AFTER PRN The printed memory image is cleared after completing printing.
CLEAR KEY
PAGE Pressing CLEAR button on the remote control unit, images of the
memorized page being selected are cleared.
ALL Pressing CLEAR button on the remote control unit, all of the stored
images are cleared.
RS232C SET RS-232C setting display
BAUD RATE Sets the baud rate of RS-232C.
Set the baud rate according to the connecting device.
REMOTE SET Remote signal setting display
BUSY LEVEL Selects how to output the BUSY signal of the remote
terminals 1 and 2 on the rear panel.
Low The VCP cannot accept the remote input signal when the signal is “LOW”.
High The VCP cannot accept the remote input signal when the signal is “HIGH”.
BUSY 1,2 SELECT Selects when the BUSY signal of the remote terminals 1 and
2 output on the rear panel.
PRINTING Outputs BUSY signal during printing.
MECHA ERR Outputs BUSY signal when a mechanical error occurs in this unit or
IC chip is not installed.
MEDIA ERR Outputs BUSY signal when an error for paper or ink sheet occurs.
MEMORY STOP Outputs BUSY signal when MEMORY button is not functioning.
STROBE 1V After outputting BUSY signal, memory is taken in by waiting to 1
vertical period.
STROBE 2V After outputting BUSY signal, memory is taken in by waiting to 2
vertical periods.
REMAINING Outputs BUSY signal while the remains of ink sheet becomes the
value set in REMAINING BUZZER.
• When either STROBE 1V or STROBE 2V is set to OFF, the other is available for
setting.
RS-232C SET
BAUD RATE :1200/2400/4800/9600
REMOTE SET
BUSY LEVEL LOW/HIGH
BUSY1,2 SELECT
PRINTING OFF/1/2/1&2
MECHA ERR OFF/1/2/1&2
MEDIA ERR OFF/1/2/1&2
MEMORY STOP OFF/1/2/1&2
STROBE 1V OFF/1/2/1&2
STROBE 2V OFF/1/2/1&2
REMAINING OFF/1/2/1&2
MEM&MONI : OFF
SOURCE MEMORY
SOURCE
MEMORY
About 2 seconds
MEM&MONI : ON
KEEP MONI : OFF
SOURCE MEMORY
SOURCE
MEMORY
PRINT
MEM&MONI : ON
KEEP MONI : ON
SOURCE MEMORY
MEMORY
PRINT
Display
Display
Display