Instruction manual

18
MULTIPLE COPY OR CONTINUOUS PRINTING
Multiple copies of a memorized image can be made by setting the number of prints to
more than one. The print quantity can be set for up to 200 prints or for continuous
printing until the paper or ink sheet is used up. Multiple quantity printing can be
cancelled if needed.
NOTE
The number of prints is displayed on the monitor for 3 seconds after pressing ,
buttons.
Press PRINT Q’ty , button to set the number of sheets to be
printed.
• The number will increase by pressing and decrease by pressing .
• The number switches in the order of;
1←→2← • • • → 9 ←→ 10 ←→ 20 ←→ 30 ←→ 40 ←→ 50 ←→ 100 ←→ 200 ←→ C ←→ 1
When you set “C”, continuous printing will be done until the paper or ink sheet is
used up.
Press PRINT button.
• The number of prints you set is printed.
• During continuous printing (except for selecting “C”), the set number will be counted
down every time one sheet is printed. When printing is completed, the counter will
be reset to the original set number. This will not reset when turning off the power (It
will not be reset to “1”.)
• If you wish to reset the number of prints to 1;
• If you wish to reset the number of prints to 1, press STOP buttons.
• If you wish to stop printing;
• Press PRINT Q’ty or button. After printing the current page, the
counter will be reset to “1”. Pressing PRINT Q’ty or button is also
available to cancel the reserved printing.
• If you wish to stop printing without completing the current page, press STOP
button. The incomplete image will be printed out.
NOTE
• If a blackish image is continuously printed, the internal temperature may rise and
cause the unit to switch to a stand-by condition during printing. In this case, an error
message “OVER HEAT” will be displayed on the monitor. Wait until the error message
goes off. When temperature drops and the message goes off, printing resumes.
PRINTING (BASIC)