Instruction manual

USAGE AND KEEPING OF PAPER SHEET SET

BEFORE PRINTING

• Fingerprints or dust on the paper’s surface may degrade print quality and cause paper jams.

Immediately after the paper is replaced, 2 images may be printed with a blank part due to

hand’s dust or oil. Refer to Pages 11-12.

• When print paper is rapidly transferred from a cool place to a hot place, vapor or dew will be

generated on the paper’s surface causing paper jams or degraded print quality. Leave the

print paper in the room to stabilize its temperature before using it.

• When print paper and ink sheet run out during printing, the printing operation stops and the

error messages such as “CHANGE PAPER” and “CHANGE INK” is displayed on the monitor.

Set new ink sheet or print paper. Refer to Page 34.

AFTER PRINTING

• When the printed paper is touched by a wet hand, the print may be discolored.

• Fading may occur if the print-face is exposed to organic chemical agents which may affect

print paper (e.g. alcohol, ester, ketone based).

• Fading will be accelerated upon contact with PVC-based materials (e.g. adhesive tapes,

rubber erasers, etc.).

STORAGE

• Avoid storing prints in direct sunlight or places with high humidity.

• Leaving the print paper in contact with PVC-based materials causes color of print paper to

come off and to be stained.

• Never store print paper in places that are close to heater, hot, humid or dusty.

Keep print paper in a place where;

Temperature : 5°C - 30 °C

Humidity : 20 % - 60 %RH

BEFORE OPERATION

NOTE

If the power is turned on and AUTO FEED&CUT on SYSTEM SETUP menu is set to ON,

“SET PAPER” disappears when print paper is set. (For AUTO FEED&CUT setting refer to

page 29.) After inserting ink sheet and closing the printing unit, the print paper is automatically

fed and cut twice.

NOTE

Take the print paper one by one after completing printing. Pull out the tray completely when

using it. If you fail to do so, paper jamming may occur.

Put the tray back when finishing printing.